The height of the pumping unit suction pipe inlet relative to the riverbed bottom

Nazir Ikramov,Takhir Majidov,Eduard Kan,Doniyor Akhunov,Eduard Kan and Doniyor Akhunov
DOI: https://doi.org/10.1088/1757-899X/1030/1/012125
2021-01-15
IOP Conference Series: Materials Science and Engineering
Abstract:Currently, 78% of all irrigated land in Uzbekistan is provided with water by pumping stations and installations. The water sources of most pumping stations are rivers and irrigation channels that transport a large amount of bottom and suspended sediments. Due to the lack of consideration of bottom sediments moving in the form of ridges, when installing the pumping units suction pipeline, during their operation, these bottom pumps flow from the water intake source in the interior of the units. As a result, intensive waterjet wear of the flow part and the impeller of the pumps occurs. This leads to an intensive reduction in the main parameters of the pumps, as well as reduces their repair period. Currently, this is one of the major problems of pumping stations that take water from the Zarafshan river, as well as those operating on the Karshi, Amu-Bukhara, Amu-Zang and Jizzakh main channels. Laboratory studies were carried out on the experimental installation to determine the height of ridges with different granulometric composition of bottom sediments. As a result, a formula was obtained for determining the height of the ridge, taking into account the heterogeneity of ridge forms. Based on the obtained formula, a method for setting the height of the pumping unit suction pipe inlet relative to the riverbed bottom is recommended. The application of the proposed method does not allow bottom sediments to enter the inner part of the pumps, as a result of which their intensive abrasive wear decreases, the inter-repair period increases, while maintaining its main parameters for a long time.
What problem does this paper attempt to address?