Cervix Type and Cervical Cancer Classification System Using Deep Learning Techniques

Lidiya Wubshet Habtemariam,Elbetel Taye Zewde,Gizeaddis Lamesgin Simegn
DOI: https://doi.org/10.2147/MDER.S366303
2022-06-16
Medical Devices: Evidence and Research
Abstract:Lidiya Wubshet Habtemariam, 1 Elbetel Taye Zewde, 1, 2 Gizeaddis Lamesgin Simegn 1, 2 1 Biomedical Imaging Unit, School of Biomedical Engineering, Jimma Institute of Technology, Jimma University, Jimma, Ethiopia; 2 AI and Biomedical Imaging Research unit, Jimma Institute of Technology, Jimma University, Jimma, Ethiopia Correspondence: Gizeaddis Lamesgin Simegn, Tel +251913925481, Email Purpose: Cervical cancer is the 4th most common cancer among women, worldwide. Incidence and mortality rates are consistently increasing, especially in developing countries, due to the shortage of screening facilities, limited skilled professionals, and lack of awareness. Cervical cancer is screened using visual inspection after application of acetic acid (VIA), papanicolaou (Pap) test, human papillomavirus (HPV) test and histopathology test. Inter- and intra-observer variability may occur during the manual diagnosis procedure, resulting in misdiagnosis. The purpose of this study was to develop an integrated and robust system for automatic cervix type and cervical cancer classification using deep learning techniques. Methods: 4005 colposcopy images and 915 histopathology images were collected from different local health facilities and online public datasets. Different pre-trained models were trained and compared for cervix type classification. Prior to classification, the region of interest (ROI) was extracted from cervix images by training and validating a lightweight MobileNetv2-YOLOv3 model to detect the transformation region. The extracted cervix images were then fed to the EffecientNetb0 model for cervix type classification. For cervical cancer classification, an EffecientNetB0 pre-trained model was trained and validated using histogram matched histopathological images. Results: Mean average precision (mAP) of 99.88% for the region of interest (ROI) extraction, and test accuracies of 96.84% and 94.5% were achieved for the cervix type and cervical cancer classification, respectively. Conclusion: The experimental results demonstrate that the proposed system can be used as a decision support tool in the diagnosis of cervical cancer, especially in low resources settings, where the expertise and the means are limited. Keywords: cervical cancer, cervix type, classification, deep learning, detection, histopathology image, transformation zone The cervix is part of the female reproductive organ structurally found at the lower fibromuscular portion of the uterus. It contains two kinds of cells: rectangular columnar cells and flat scale-like squamous cells. Abnormal cells are developed in the transformation zone, which is an area where columnar cells are constantly changing into squamous cells. 1 The location of the transformation zone varies among women. Based on transformation zone location, cervix is classified as cervix type 1, type 2, and type 3. 2,3 The cells in the transformation zone develop gradually to abnormal cells and could change into cervical cancer through time. Cervical cancer is one of the leading causes of cancer-related deaths in women, worldwide, with 80% of the cases occurring in developing countries. 4,5 According to the human papillomavirus (HPV) information center report, about 6294 new cervical cancer cases are diagnosed annually in Ethiopia. 6 In remote areas, which have poor medical conditions with insufficient healthcare accessibility and unqualified medical staff, cervical cancer incidence and mortality are estimated to be higher. Cervical cancer screening techniques include visual inspection after application of acetic acid (VIA), 7 papanicolaou test (Pap), 3,8 and human papillomavirus (HPV) test. 9 The type of cervical cancer is confirmed by visual examination of histopathology images under a microscope. These manual techniques are usually tedious, time-taking, and prone to error due to inter- and intra-observer variability. Computer-aided diagnosis (CAD) techniques have the potential to automate the manual screening and diagnosis procedures and help medical professionals in a wide range of decision-making, including disease detection, localization of cervix, cancer grading, and treatment planning. Cervix type classification has been proposed in the literature using the transfer learning approach. 10–12 Inception v3, ResNet 50, and ResNet 34 pre-trained models were employed in these literatures to classify cervix into type 1, type 2 and type 3. However, the accuracies reported were generally low. Similarly, a two-stage solution which performs classification of cervix type following region of interest (ROI) extraction were proposed in different literatures. 13–19< -Abstract Truncated-
What problem does this paper attempt to address?