Abstract:Effect of varying surface structures of the inner rotating cylinder on characteristics of droplet formed in a liquid-liquid Taylor-Couette (TC) reactor is investigated. Two novel surface structures of inner cylinders, designed with axially corrugated surface (N40) and with typical three-dimensional roughness (NZ40), respectively, were adopted for the investigation. The high-speed camera visualization was used to measure the droplet size while CFD modelling was applied to predict the fluid dynamics of TC flows with such two inner cylinders and a smooth surface inner cylinder, thus revealing the effect of inner cylinder configuration on the droplet formation in the TC flows. The experimental results have clearly indicated that both the rotation speed and surface configuration variation of the inner cylinders affect the generated droplet size and distribution. As the rotation speed increases, the droplet size is obviously reduced for all types of inner cylinder configurations. Compared with the conventional smooth surface inner cylinder, the two new types of inner cylinders with special surface structures can produce much smaller droplets, especially for the case of N40 surface structure inner cylinder, with which the smallest droplet size was found at all the experimental conditions. CFD modelling results have demonstrated that the surface configurations of inner cylinder can significantly affect the turbulence generation, consequently altering the distributions of turbulent kinetic energy and local turbulence shear strain rate. As a result, the droplet size was found to be controlled by the change of the local turbulent dissipation rate that was strongly associated with the surface structures of inner cylinders. Empirical correlations that correlate the droplet size with the Weber number and Reynolds number were proposed based on the high-speed camera visualization data.(c) 2022 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0/).

The internal flow behaviors during Taylor cone formation of pulsating electrohydrodynamic jet printing

Numerical investigation of high-frequency pulsating electrohydrodynamic jet at low electric Bond numbers

Numerical analysis of electrohydrodynamic jet printing under constant and step change of electric voltages

Effect of Inner Cylinder Configuration on Liquid Droplet Dispersion and Size Distributions in a Taylor-Couette Reactor

Numerical study on the influence of fluid properties in constant-voltage electrohydrodynamic pulsating jets

Numerical Simulation of Turbulent Taylor-Couette Flow with High Taylor Number and Large Radius Ratio in High-Speed Canned Motor Pump Internals

Numerical study on the effects of fluid properties in electrohydrodynamic pulsating jet under constant voltage

Numerical modeling and analysis of coaxial electrohydrodynamic jet printing

Pulsation mechanism of a Taylor cone under a single pulse voltage

Electric Field-Assisted Droplet Formation Using Piezoactuation-Based Drop-On-Demand Inkjet Printing

Pulsating modes of a Taylor cone under an unsteady electric field

Occurrence of Taylor Vortices in the Flow Between Two Rotating Conical Cylinders

Instability Analysis of the Cone–jet Flow in Liquid-Driven Flow Focusing

Study on Turbulent Taylor-Couette Flow with High Reynolds Number and Large Radius Ratio in High-Speed Canned Motor Pump Internals

Experimental and Numerical Study on Dynamics of Viscoelastic Liquid Cone in Flow Focusing

Numerical Simulation of the Cone–jet Formation and Current Generation in Electrostatic Spray—modeling As Regards Space Charged Droplet Effect

Transient Radial Spray from Electrified Viscous Jets

The Effect of External Voltage on Pulsed Electrohydrodynamic Printing

Parametric Study on Stability and Morphology of Liquid Cone in Flow Focusing

Vorticity-induced flow-focusing leads to bubble entrainment in an inkjet printhead: synchrotron X-ray and volume-of-fluid visualizations

Internal flow mechanism of cone-straight nozzle