Hydrothermal carbon modified Cu–Fe oxide with enhanced Fe(II)/Fe(III) cycle to activate peroxydisulfate for phenol removal

Meng Fan,Jianxin Liu,Yawen Wang,Xiaochao Zhang,Rui Li,Changming Zhang,Rui Lv,Caimei Fan,Yunfang Wang

DOI: https://doi.org/10.1007/s10971-022-05841-w

2022-05-27

Abstract:Phenol is a typical organic pollutant in wastewater, which will cause considerable damage and threat to the ecosystem and human health. In this work, hydrothermal carbon (HTC) modified copper-iron oxide (CFO) was synthesized using sol-gel method, and employed as heterogeneous catalyst to activate peroxydisulfate (PDS) for degrade phenol. The composition, morphology and specific surface area of the catalyst were determined by XRD, SEM-EDS and BET, and the functional groups and valence states of elements on the catalyst surface were analyzed by FTIR and XPS. The effects of some key parameters including HTC content, initial pH value, and coexisting inorganic anions on the removal efficiency of phenol in the system were investigated. The removal rate of phenol and TOC could be reached 90.17% and 84.43% at: phenol initial concentration 20 mg/L, CFO:HTC mass ratio 30: 1 (CFO–H2), PDS dosage 0.6 g/L, and catalyst dosage 0.31 g/L, under the condition of not adjusting the pH value and avoiding light. In addition, the possible mechanism of PDS activation by CFO–H2 was proposed. The reason for the efficient performance of PDS activation by CFO–H catalyst could be assignable to the synergistic effect of HTC and CFO. HTC and Cu(I) on the surface of catalyst greatly facilitated the conversion from Fe(III) to Fe(II), which was conductive to the generation of active free radicals during the reaction process. This study provides a new idea for the design of heterogeneous catalysts for the efficient treatment of organic pollutants with PDS.

materials science, ceramics