Abstract:The unloading and reloading of geostress during the excavation of large underground caverns tends to bring about large deformation and failure problems of rock masses with interlayer staggered zones (ISZs), posing significant threats to the safety and stability of the underground cavern. Hence, for interlayer staggered zones with complex mechanical response behaviors, a series of conventional triaxial cyclic loading tests under different confining pressures were carried out. It can be seen from these results that the envelop curves of stress–strain relations were of obvious memory, but the peak deviator stress, internal friction angle, and cohesion were lower than those in monotonic loading. The phenomenon of volume expansion occurred in the whole process of cyclic loading and unloading, and the unloading dilatation seemed to be more sensitive to relatively low confining pressure. The volume expansion reached its highest value when the unloading stress level (i.e., the ratio of the stress ratio in the process of the cyclic test to the stress ratio when the ISZ comes to the failure point) increased to more or less 0.6∼0.8. Moreover, the changing trend of the average rebound modulus was humplike with the increase of unloading stress level, and the ratio of average rebound modulus to monotonic initial elastic modulus declined as a power function. Additionally, the validity of the unloading rebound modulus calculation by the Duncan-Chang model is proved. The analysis of energy consumption in plastic hysteresis loops indicates that the plastic hysteresis energy of the specimen in each cycle rose with the stress level’s increase. Further microscopic failure mechanism analysis shows that the previous research results are synthetically affected by factors including particle motion and breakage, initiation and propagation of original and new fractures, yield, and damage of interlayer staggered zones. This research provides a theoretical premise for exploring the cyclic unloading and reloading stress path influence on the failure of surrounding rock with ISZs, as well as for more reasonable mechanical parameter selection in deep underground excavations.

Experimental Study on Mechanical Properties and Stability Analysis of Structural Plane under Unloading Normal Stress

Study Of Shear Strength Characteristics Of Simulation Rock Structural Planes Based On Multi-Size Direct Shear Tests

EXPERIMENTAL STUDY OF STRESS EFFECT ON PEAK FRICTION ANGLE OF ROCK STRUCTURAL PLANE

Mechanical Properties and Acoustic Emission Characteristics of Anchored Structure Plane with Different JRC under Direct Shear Test

Effects of Undulation and Stress on the Shear Mechanical Behavior of Saw-Toothed Discontinuities Under Unloading Normal Stress

DDM Analysis of the Effect of Non-Linear Structural Plane on In Situ Stress Field

Experimental Study on Shear Behavior of Rock Composite Material under Normal Unloading Conditions

Experimental Study on the Effect of Single Structural Plane on the Stability of Shallow Tunnel Surrounding Rock

Effect of unloading rate of normal stress on the frictional slip behaviour of fractured rocks

An Experimental Investigation on the Foliation Strike-Angle Effect of Layered Hard Rock under Engineering Triaxial Stress Path

Influence of Deviatoric Stress on the Deformation and Damage Evolution of Surrounding Rock under Unloading Conditions

Experimental investigation on mechanical characteristics of red sandstone under graded cyclic loading and its inspirations for stability of overlying strata

Effect of Unloading Rate on the Mechanical Behavior and Fracture Characteristics of Sandstones Under Complex Triaxial Stress Conditions

Experimental Study of Mechanical Behavior of Interlayer Staggered Zone under Cyclic Loading and Unloading Condition

Mechanical characteristics and energy evolution in a rock mass with a weak structural plane

Experimental Investigation on Shear Mechanical Behavior of Sandstone Containing a Pre-existing Flaw Under Unloading Normal Stress with Constant Shear Stress

Experiment and particle flow simulation of unloading induced shearing properties for jointed sandstone materials

Study on dynamic characteristics of sandstone-damaged by loading and unloading

Study on a Nonlinear Shear Damage Constitutive of Structural Plane and Application of Discrete Element

Study on Shear Slip Characteristics of Sandstone Plane Joints under Normal Dynamic Load Disturbance

Analysis Of Low-Angle Structural-Plane Appearance From Effect Of Moment Of Force And Groundwater