Abstract:The study of the adhesion of solid and liquid aqueous phases to superhydrophobic surfaces has become an attractive topic for researchers in various fields as a vital step in the design of icephobic coatings. The analysis of the available results shows that the experimentally measured values of adhesion strength for superhydrophobic substrates, which in some cases are quite small, are still essentially higher than might be expected from the portion of the actual wetted area. In this study we have considered the peculiarities of the three-phase contact zone between sessile supercooled water or ice droplets and a superhydrophobic coating at negative temperatures (below 0 °C) and during the water-ice phase transition. Two types of superhydrophobic coatings with very different textures were used to analyze the evolution of shape parameters of a sessile water droplet during droplet cooling and freezing. It was shown that the evolution of the contact angle and droplet contact diameter of a water droplet deposited on a superhydrophobic surface does not undergo essential changes when the droplet is cooled simultaneously with the substrate and the surrounding environment, and the humidity is maintained close to 100% during the cooling process. However, the phase transition from supercooled water to ice droplets leads to the growth of a metastable iced meniscus and a frost halo in the vicinity of the three-phase contact zone. The meniscus effectively increases the area of adhesive contact between the droplet and the substrate. This phenomenon is intrinsically related to the release of the heat of crystallization and is responsible for the enhancement of adhesion to a superhydrophobic substrate upon droplet transition from supercooled water to ice. At the same time, it was shown that the metastable state of the above meniscus leads to its spontaneous sublimation during exposure at negative temperatures.

The Study of the Strength of Adhesion Contact of Ice on Surfaces with Different Wettabilities

Superhydrophobic versus SLIPS: Temperature dependence and the stability of ice adhesion strength

Effect of Shear Loading Conditions on the Measured Strength of Ice Adhesion to Superhydrophobic Surfaces

Interlaboratory Study of Ice Adhesion Using Different Techniques

Water and Ice Adhesion to Solid Surfaces: Common and Specific, the Impact of Temperature and Surface Wettability

Review of the State of the Art in Studying Adhesion Phenomena at Interfaces of Solids with Solid and Liquid Aqueous Media

Unraveling the Synergistic Effects of Solid Surface Material and Temperature on the Contact Angle of Water under an Elevated Pressure: an Experimental Study

Experimental Investigation on Ice–Aluminum Interface Adhesion Strength under Heating Conditions

A New Measuring System for the Determination of the Ice Adhesion Strength on Smooth Surfaces

Supercooled Water Droplet Impact on Superhydrophobic Surfaces with Various Roughness and Temperature

A high throughput tensile ice adhesion measurement system

Intrinsic dependence of ice adhesion strength on surface roughness

Why the adhesion strength is not enough to assess ice adhesion on surfaces

Tensile and Shear Test Methods for Quantifying the Ice Adhesion Strength to a Surface

Role of water vapor desublimation in the adhesion of an iced droplet to a superhydrophobic surface

Ice Adhesion Characterization Using Mode-I and Mode-II Fracture Configurations

Parameter Study for the Ice Adhesion Centrifuge Test

Thermodynamic method for establishment of relationship between icephobicity/superhydrophobicity and microstructure-Based on computing for adhesion work

Comparative Evaluation of the Shear Adhesion Strength of Ice on PTFE Solid Lubricant

In situ investigation of ice formation on surfaces with representative wettability

Nanoscale Correlations of Ice Adhesion Strength and Water Contact Angle