Abstract:Sound propagation in shallow water is significantly influenced by geoacoustic properties. Estimating these geoacoustic parameters is essential for sound field analysis and sonar performance assessment. As a common practice, the seafloor is often treated as a single-layer or two-layer range-independent geoacoustic model to reduce the number of involved parameters. However, acoustic parameters inverted through these two geoacoustic models are typically limited in their applicability to a specific frequency range, posing challenges when applied across a broader frequency range. A range-dependent multi-layer geoacoustic model based on experimental measurements obtained with a sub-bottom profiler is proposed in this study. The inversion scheme combines three inversion methods to estimate geoacoustic parameters, considering the different sensitivities of geoacoustic parameters to different physical parameters within the acoustic field. Firstly, modal dispersion is used to invert the geoacoustic parameters of each layer, with the dispersion curve obtained through warping transform and the Wigner-Ville distribution. After that, both the localization using matched field processing and the dispersion curve fitting demonstrate the effectiveness of the inversion results for each layer, despite the peak of the probability distribution of sound speed in the first layer is broader than in others. Subsequently, matched field processing is employed to invert the geoacoustic parameters of the first layer. This method is based on the theory that as frequency increases, the depth of sound rays penetrating the seabed decreases, revealing changes in the first layer's sound speed with the seabed depth. Finally, bottom attenuation coefficients at different frequencies are inverted by the transmission loss (TL), and a fitting relationship between the attenuation coefficients and the frequencies is derived.In the discussion, the inversion results obtained using the range-dependent multi-layer geoacoustic model are compared with results estimated by the single-layer geoacoustic model. The findings indicate that the transmission loss (TL) error calculated by the range-dependent multi-layer geoacoustic model in this study is smaller than that calculated by the single-layer geoacoustic model, especially in the lower frequency band. The range-dependent multi-layer geoacoustic model proves to be suitable for a broader frequency range, providing better precision in explaining various acoustic phenomena.

Review of Geoacoustic Inversion in Underwater Acoustics

Experimental Demonstration Of Acoustic Inversion Using An Auv Carrying Source

Inversion of the Sound Speed Profiles with an AUV Carrying Source Using Improved Ensemble Kalman Filter

Inversion of Internal Wave-Perturbed Sound-Speed Field Via Acoustic Data Assimilation

Inversion of internal wave-perturbed ocean environments via acoustic data assimilation

Kullback-Leibler Divergence Based Performace Evaluation of Geoacoustic Inverison Using Sources of Opportunity

Reflection Waveform Inversion Based on Full-Band Seismic Data Reconstruction for Salt Structure Inversion

Reflection Multi‐scale Envelope Inversion

Inversion of Ocean Environmental Variations Via Time-Reversal Acoustics

Bayesian geoacoustic parameters inversion for multi-layer seabed in shallow sea using underwater acoustic field

Study of acoustic tomography based on data assimilation for shallow water environments

Inversion of shallow seabed structure and geoacoustic parameters with waveguide characteristic impedance based on Bayesian approach

Bottom Multi-Parameter Bayesian Inversion Based on an Acoustic Backscattering Model

Shallow water low frequency inversion on basis of range-dependent multi-layer geoacoustical model

Bayesian geoacoustic inversion in shallow water with vertical coherence of ship-radiated noise

Geoacoustic Model Parameter Estimation Using a Bottom-Moored Hydrophone Array

Investigation of geoacoustic parameters of fine-grained sediment in the South China Sea using sequential inversion

Geoacoustic Inversion of the Acoustic-Pressure Vertical Phase Gradient from a Single Vector Sensor.

Geoacoustic inversion based on single receiver measurement

Geo‐acoustic Inversion with Vector Sensors in Shallow Water.