Abstract:This paper describes the use of an electric drive as an acoustic actuator for active noise cancellation (ANC). In the presented application, the idea is to improve the noise, vibration, harshness (NVH) characteristics of passenger cars without using additional active or passive damper systems. Many of the already existing electric drives in cars are equipped with the required hardware components to generate noise and vibration, which can be used as compensation signals in an ANC application. To demonstrate the applicability of the idea, the electrical power steering (EPS) motor is stimulated with a control signal, generated by an adaptive feedforward controller, to reduce harmonic disturbances at the driver's ears. As it turns out, the EPS system generates higher harmonics of the harmonic compensation signal due to nonlinearities in the acoustic transfer path using a harmonic excitation signal. The higher harmonics impair an improvement in the subjective hearing experience, although the airborne noise level of the harmonic disturbance signal can be clearly reduced at the driver's ears. Therefore, two methods are presented to reduce the amplitude of the higher harmonics. The first method is to limit the filter weights of the algorithm to reduce the amplitude of the harmonic compensation signal. The filter amplitude limitation also leads to a lower amplitude of the higher harmonics, generated by the permanent magnet synchronous machine (PMSM). The second method uses a parallel structure of adaptive filters to actively reduce the amplitude of the higher harmonics. Finally, the effectiveness of the proposed ANC system is demonstrated in two real driving situations, where in one case a synthetic noise/vibration induced by a shaker on the front axle carrier is considered to be the disturbance, and in the other case, the disturbance is a harmonic vibration generated by the combustion engine. In both cases, the subjective hearing experience of the driver could be clearly improved using the EPS motor as ANC actuator.

Automotive Electric Power Steering Systems NVH Performance Investigations

Dynamic NVH Numerical Analysis of Power Steering in the Presence of Lubricant in the System

A Comprehensive Study of Vibration Suppression and Optimization of an Electric Power Steering System

A Study on the Noise and Vibration Testing System for Automotive Final Drive

Evaluation of steering wheel vibration in electric vehicles and application to Dynamic Motor Drive

Feasibility Analysis for Active Noise Cancellation Using the Electrical Power Steering Motor

Simulation of the Electric Power Steering System

Modelling and Analysis for an Electric Power Assisted Steering System of Plug-In Hybrid Electric Car

Development of In-Vehicle Evaluation System for Steering Assistance Performance of Electric Power Steering

Performance Assessment of an Electric Power Steering System for Driverless Formula Student Vehicles

Exploration of the Reliability of Automotive Electronic Power Steering System Using Device Junction Electrothermal Profile Cycle

Fault Detection Methods for Electric Power Steering System Using Hardware in the Loop Simulation

Analysis of the effect of electric power steering system to vehicle handling performance

Hardware-in-loop Simulation Test Platform of Electric Power Steering System Using Two Servo Motors

Experimental Study on EPS System Performance

Analysis of Stability for Nonlinear Closed-loop Vehicle Equipped with Electric Power Steering System

Control Performance Analysis of Power Steering System Electromechanical Dynamics

Comparative Study of Motor Topologies for Electric Power Steering System

Study on Stability and Disturbance Resistance of Electric Power Steering Control System

A Hybrid Lumped Parameters/Finite Element/Boundary Element Model to Predict the Vibroacoustic Characteristics of an Axial Piston Pump

Reliability improvement of electric power steering system based on ISO 26262