Abstract:Introduction. Currently, more than 500 million tons of fly ash have been accumulated on the territory of the Republic of Kazakhstan, the volume of which will increase to one billion tons by 2030. Such accumulation of fly ash in storages creates a powerful anthropogenic impact on the biogeocenosis. A significant proportion of these man-made materials are formed during the burning of Ekibastuz coals. There is practically no processing of ash and slag waste on an industrial scale. For various reasons, ash dumps are not used in Kazakhstan, because the physico-chemical properties have been very poorly studied, in addition, during their processing, other wastes or ash dumps unsuitable for use are obtained from these wastes, because they contain a lot of unburned coal. As of 01.01.2020, the share of recycled, reused, burnt ash and slag waste in Kazakhstan amounted to 0.7%. The relevance and significance of this problem is due to the fact that man-made waste from CHP plants is not sufficiently processed, and current ash waste accumulates and occupies huge areas, which removes them from land use. Knowledge of the chemical composition of the ash will allow it to be used to obtain building materials. The purpose of this work is to study the properties of ash and slag waste during the burning of coal from the Ekibastuz deposit in Kazakhstan, to assess them as a source of environmental pollution, to determine the possibility of obtaining demanded building materials from them. Research methods. To determine the phase composition of the studied material, an upgraded diffractometer DRON-3M on CuKa radiation with software was used. Radiographs of the sample were obtained in the range of 2° (angles) from 10 to 70°. The chemical composition was determined using an energy dispersion spectrometer “EDX-8000”. Micrography of fly ash was taken on a scanning electron microscope Superprob-733. Research materials. Ash and slag waste from the burning of coal from the Ekibastuz deposit in Kazakhstan. Research results and discussion. The physical characteristics of ash have been established: specific surface area – ~200 m2/kg, true density – 2.1 g/cm3, bulk density – ~780 kg/m3. Fractional composition: the highest content of particles with a size of 100 microns (25.8%), 80 microns (12.12%), 50 microns (21.46%) and 45 microns (21.38%); at the same time, unburned carbon is concentrated in large fractions, glass phase – in small ones. Analysis of the chemical composition of Ekibastuzky ash allowed to find out the composition of coal minerals. The main components are silicon and aluminum oxides, and there is also a large amount of iron oxide. Knowledge of the chemical composition of ash allows it to be used in the production of building materials. Conclusion. The results of the conducted studies have shown the possibility of using ash and slag waste as secondary raw materials in the construction of road materials in order to reduce the anthropogenic load on the environment.

The physical and chemical composition of fly ash from Troitsk state district power plant (GRES) and its potential use in the construction industry

POTENTIAL FOR THE USE OF ASH AND SLAG FROM COAL-FIRED THERMAL POWER PLANTS FOR PRODUCTION OF ALTERNATIVE FUELS (ON THE EXAMPLE OF ASH AND SLAG FROM LADYZHYNSKA THERMAL POWER PLANT)

Assessment of ash and slag waste as a source of environmental pollution and as a source of secondary raw materials

Utilization of Mechanochemically Pretreated Municipal Solid Waste Incineration Fly Ash for Supplementary Cementitious Material

Experimental determination of the solid phase density of thermal power plant ash

Evaluation on Reactivity of Fly Ash from Different Sources in Alkali Activated System-Progressing Environmentally Construction Through Waste Utilization

Possible Applications of Hardening Slurries with Fly Ash from Thermal Treatment of Municipal Sewage Sludge in Environmental Protection Structures

Study of Matrix and Rare Elements in Ash and Slag Waste of a Thermal Power Plant Concerning the Possibility of their Extraction

Using Fly Ash Wastes for the Development of New Building Materials with Improved Compressive Strength

THE MATERIAL COMPOSITION AND PROPERTIES OF ASH FROM THE INCINERATION OF DOMESTIC SEWAGE SLUDGE

Fly Ash from the Thermal Transformation of Sewage Sludge as an Additive to Concrete Resistant to Environmental Influences in Communication Tunnels

The use of fractionated fly ash of thermal power plants as binder for production of briquettes of coke breeze and dust

A review on fly ash utilization

The Physical and Chemical Properties of Fly Ash from Coal Gasification and Study on Its Recycling Utilization

State of the art review on physiochemical and engineering characteristics of fly ash and its applications

Properties of High volume GGBFS and High Volume Flyash Concrete: A Brief Review

Effective utilization of Coal Fly Ash (CFA): perspectives and opportunities in various industrial sectors and hydrocarbon extraction processes

Effective use of fly ash slurry as fill material

Utilization of Fly Ashes from Fluidized Bed Combustion: A Review

РROSPECTS FOR THE USE OF ENERGY PRODUCTION WASTE IN CONSTRUCTION CERAMICS

Waste to concrete material: Potential Study of Chemical Characterization of Coal Fly Ash and Bottom Ash