Particulate matter concentrations and characterization in urban subway system-case study Tehran, Iran

Mahya Parchami,Majid Shafiepour Motlagh,Alireza Pardakhti
DOI: https://doi.org/10.1007/s40201-022-00838-7
IF: 3.433
2022-10-28
Journal of Environmental Health Science and Engineering
Abstract:The present work aims to evaluate the indoor and outdoor air quality in the stations of the Tehran subway system. In this study, the particulate sampling of the four Tehran subway stations was conducted in March-July 2018 during different seasons to determine indoor and outdoor PM 10 and PM 2.5 concentrations and elemental composition. The samples were analyzed to determine 11 elements such as Pb(Lead), Cd(Cadmium), Ni(Nickel), Co(Cobalt), Mn(Manganese), Zn(Zink), Fe(Iron), Cu(Copper), As(Arsenic), Al(Aluminum) and Cr(Chromium) qualitatively. The experimental results indicated that the average concentrations of both PM 10 and PM 2.5 in indoor stations (platforms) were approximately 2–5 times higher than those in the outdoors (ambient air). In addition, PM 10 and PM 2.5 concentrations exceeded the daily-standard values (US-EPA; PM 10 = 50 μg.m -3 , PM 2.5 = 25 μg.m -3 ) in 100% indoor measurements and 84% outdoor measurements. Moreover, the average indoor PM 10 and PM 2.5 concentrations in weekday values were 1.4 and 1.5 times higher than those measured on weekends, which may be related to the lower frequency of trains. Further, indoor and outdoor correlation of PM 10 concentrations (Pearson r = 0.6) was more than that of PM 2.5 concentrations (Pearson r = 0.2), indicating the additional sources for PM 2.5 in indoor stations. Additionally, the average PM 2.5 / PM 10 ratio was 0.52 for indoor measurements and 0.34 for outdoors, indicating that PM 10 particles were the dominant particle type in both sampling areas and passengers in indoor stations exposed to higher PM 2.5 concentrations than those in outdoor stations. Finally, based on elemental analysis, Fe was the most enriched element in indoor and outdoor PM 10 and PM 2.5 samples. The concentration of Fe ranged from 16 to 81 μg.m -3 in indoor stations and 0.6 to 2.5 μg.m -3 in outdoors. Other enriched elements were Al, Cu, Zn, and Mn, respectively.
environmental sciences,engineering, environmental
What problem does this paper attempt to address?