Abstract:High cost of custom-made conventional turbines and the lack of local manufacturing facilities have created significant obstacles to the development of Pico/micro hydroelectric schemes in the country. In this context it has been identified pump as turbine (PAT) electric schemes can have distinct advantages over conventional turbines because pumps are manufactured locally at mass scale and available in various sizes. But not all pumps are suitable for use as PAT because they have different design details and manufacturing qualities. The performance of a pump used as a turbine is assessed based on two primary parameters: turbine mode head and flow at the Best Efficiency Point (BEP). There are various methods available in the literature for predicting PAT theoretical head and flow at BEP. These methods aim to estimate how the pump will perform when used as a turbine. Despite these prediction methods, there is a consistent deviation of approximately ±20% between the theoretical estimates and the actual measured performance. This indicates that real-world conditions and factors not accounted for in theoretical models can significantly affect the performance of PAT systems. The primary objective of the present study was to measure the deviation between the actual performance and the predicted performance of two PAT systems in terms of head and flow at BEP. This deviation was then compared to the commonly mentioned figure of ±20% in the literature. The study focused on using what it considered to be the most accurate prediction method among those presented in the literature to estimate PAT head and flow at BEP and involved running reverse, 1.1 kW, and 1.6 kW direct-drive standard centrifugal type water pumps in a test rig to measure the actual performance of the two PATs. The results of the study showed a deviation of +27% and -22% between the actual measured head and flow at BEP, and the values predicted by the theoretical method. This deviation is slightly outside the commonly mentioned range of ±20% found in the literature, but this is not expected to have a detrimental effect on the generation of electric power. This implies that, even with the observed slight deviation, the prediction method used in this study can be satisfactorily employed to estimate PAT head and flow at BEP.

Optimization-Based Methodology for Selection of Pump-as-Turbine in Water Distribution Networks: Effects of Different Objectives and Machine Operation Limits on Best Efficiency Point

Optimal selection of parallel pumps running as turbines for energy harvesting in water transmission lines considering economic parameters

Design and Year-Long Performance Evaluation of a Pump as Turbine (PAT) Pico-Hydropower Energy Recovery Device in a Water Network

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Hydropower Generation Through Pump as Turbine: Experimental Study and Potential Application to Small-Scale WDN

A New Low-Cost Technology Based on Pump as Turbines for Energy Recovery in Peripheral Water Networks Branches

Effects of impeller geometry modification on performance of pump as turbine in the urban water distribution network

Micro Hydro Power Generation from Water Supply System in High Rise Buildings Using Pump As Turbines

PATs Behavior in Pressurized Irrigation Hydrants towards Sustainability

Geometrical Optimization of Pump-As-Turbine (PAT) Impellers for Enhancing Energy Efficiency with 1-D Theory

The pump as a turbine: A review on performance prediction, performance improvement, and economic analysis

Study on the Impact of Blades Wrap Angle on the Performance of Pumps As Turbines Used in Water Supply System of High-Rise Buildings

The Impact of Surrogate Models on the Multi-Objective Optimization of Pump-As-Turbine (PAT)

Bypass Control strategy of a Pump as Turbine in a Water Distribution Network for energy recovery

Experimental Study on Single- and Multi-stage Pump as Turbine on Water Supply Pipelines

Energy Efficiency and Stability of Micro-Hydropower PAT-SEIG Systems for DC Off-Grids

Performance Prediction and Geometry Optimization for Application of Pump as Turbine: A Review

A Comparative Study between Theoretical and Measured Performance of Standard Centrifugal Pumps Running as Turbines

Optimization Pump as Turbine Coupled to a Self-Excited Induction Generator Using Multi-Objective Genetic Algorithm

Numerical and experimental study of mixed flow pump as turbine for remote rural micro hydro power plant application

Development of Modified Pump Used as Turbine in Micro Hydro Plants