Abstract:Magnetic iron oxides, mainly magnetite Fe3O4 and maghemite Y—Fe2O3, are seen as cheap, effective and convenient to use adsorbent of impurities such as heavy metals or dyes. The paper presents the influence of selected ions: inorganic monovalent and multivalent anions (NO3, Cl , SOy, PO3 ), organic anions, including complexing agents (Cl I.COO , EDTA) and monovalent and bivalent metal cations (Ca2+, Na+) on the separation of Cu(II), Zn(II), Ni(II), Cd(II), Pb(II), Cr(III) and Cr(VI) ions from solutions, using unmodified magnetite nanoparticles (M_NPs) and magnetite modified with poly(sodium acrylate) (M/PSA_NPs). The adsorption process was carried out at two pH values (5 and 6 for Cu(II), Zn(II), Ni(II), Cd(II) and 4 and 5 for Pb(II), Cr(III) and Cr(VI) ions) and at the concentration of the accompanying ion 10 times higher than the metal concentration. The reference test was carried out without the addition of accompanying salts. It was found that the increase in pH and the use of M/PSA_NPs adsorbent containing dissociated carboxylate groups -COO contributed to the increase in the degree of separation of all tested metals except for the anionic Cr(VI) form. Under the experimental conditions, inorganic monovalent anions did not show any significant effect on the process efficiency, whereas multivalent anions, especially PO(, increased the degree of separation of Cu(II), Zn(II), Ni(II) and Cd(II), which suggests that these anions may participate in the process of bonding metal cations with magnetite. A similar effect was observed for Pb(II) and Cr(III) cations using unmodified magnetite and lower pH value. The presence of a strong complexing agent (EDTA) significantly decreased the efficiency of cationic metal forms separation. The degree of this decrease depended on the type of metal and the conditions of adsorption. Cr(VI) anions were separated to a greater extent using unmodified magnetite. The presence of versenate (EDTA), phosphate and sulfate ions caused a decrease in the efficiency of the process, which may be explained by the fact that these multivalent anions compete with chromate ions in the adsorption process.

Ionic Polyacrylamides as Stability-Modifying Substances of Soil Mineral Suspensions Containing Heavy Metal Impurities

Comparison of adsorption affinity of anionic and cationic polyacrylamides for montmorillonite surface in the presence of chromium(VI) ions

Accumulation of toxic Pb(II) ions by the iron-containing minerals in the presence of ionic polyacrylamide soil conditioner

Preparation and Characterization of a Novel Macroporous Silica-Bipyridine Asymmetric Multidentate Functional Adsorbent and Its Application for Heavy Metal Palladium Removal.

Effects of polyacrylamide molecular weight and mass concentration on water transport characteristics of iron tailings

Study of the metal ion adsorption capacity of palygorskite by computer simulation

Adsorption of heavy metals on Na-montmorillonite. Effect of pH and organic substances

Effects of Soil and Water Properties on Anionic Polyacrylamide Sorption

Adsorption Characteristics of Polyacrylamide in Low Concentration Zone on Clay Minerals.

Investigation of Ionic Polymers' Stabilizing and Flocculating Properties in Dispersed Activated Carbons Systems

Influence of ionic environment on the process of adsorption of heavy metal ions on magnetic iron oxides

Polyacrylamide Hydrogel an Effective Adsorbent for the Removal of Heavy Metal from Aqueous Solution: Isotherm, Kinetic, and Thermodynamic Studies

The Adsorption of Heavy Metal Ions by Poly (Amidoamine) Dendrimer-Functionalized Nanomaterials: A Review

Impact of Montmorillonite Clay on Polysulfone Mixed Matrix Membrane for Heavy Metal Adsorption

Evaluation of the stability of heavy metal-containing sediments obtained in the wastewater treatment processes with the use of various precipitating agents

Review on stabilization/solidification methods and mechanism of heavy metals based on OPC-based binders

An environmentally friendly strategy for reducing the environmental risks of heavy metals adsorbed by kaolinite

Preparation of Humic Acid-Bentonite Polymer Composite: A Heavy Metal Ion Adsorbent

Experimental and molecular dynamics simulation study on the effect of polyacrylamide on bauxite flotation

Sustainable soil rehabilitation with multiple network structures of layered double hydroxide beads: Immobilization of heavy metals, fertilizer release, and water retention

Mussel Inspired Preparation of Amine-Functionalized Kaolin for Effective Removal of Heavy Metal Ions