Flexible, Stretchable, Waterproof (IPX7) Electro-thermal Films Based on Graphite Nanoplatelets & Polyurethane Nanocomposites for Wearable Heaters
Wei Chen,Shaoqing Yang,Huatao Wang,Ketong Yang,Xulei Wu,Feng Gao,Bojun Zheng,Kun Qian,Wang Yao,Tao Zhang,Bo Zhong,Xiaoxiao Huang
DOI: https://doi.org/10.1016/j.cej.2021.133990
IF: 15.1
2021-01-01
Chemical Engineering Journal
Abstract:Electrothermal materials have been widely used due to controllable heat energy in our life. With the development of wearable technology, a flexible, safe and waterproof heater with the good ability to endure repeated bending is required in future. In this paper, we have developed a novel wearable heater based on flexible, stretchable graphite nanoplates and polyurethane (GNP/PU) nanocomposite films. Firstly, the GNP/PU thin films with a thickness of 30-200 mu m were fabricated in mass production by the method of gap-coating, which can be bent 180 degrees repeatedly, or even knotted for their excellent flexibility, and has a maximum elongation up to 387.8%, due to the homogenous distribution of GNP in PU matrix. By the control on the amount of GNP and the thickness of the film, the minimum resistivity and square resistance of the GNP/PU films can be 80 m Omega.cm and 4 Omega/square, respectively. Through a further flexible structure designing and waterproof electronic packaging process, the fabricated wearable heaters are able to withstand 100,000 180-degrees bending with the resistance changes of only 3.24%, and have a IPX7 waterproof ability to work continuously for 120 min under 1.30 m water. Interestingly, as-prepared bare GNP/PU films have a good resistence to water and salt erosion, with the light 2.1%, 2.4% and 3.1% increasing in electrical resistance, and without obvious change in heating performance, even after the immersion in pure water, 0.5% and 5% salt water and dried completely. Furthermore, the wearable heaters can generate heat uniformly under the safe voltage of 5-24 V to achieve rapid heating and cooling rate of 25 degrees C/min and 13 degrees C/min, respectively. Lastly, a heating full-body vest mode of as-prepared wearable heaters was fabricated, which can work well with hand raising, bending and walking. The results showed that as-prepared wearable heaters were very suitable for wearable electronics, due to the excellent flexibility and stretchability of GNP/PU films and their special packaging structure, which provides a new choice for wearable heating products.