Abstract:Kilometer-scale ground-based gravitational-wave interferometers have generated a new field of astronomy by viewing the universe in gravitational wave (GW) radiation, operating at a peak sensitivity of frequencies ranging from 10s of Hz to a few kHz.1 A great many discoveries have resulted from these detectors, such as the existence of binary black hole and neutron star systems.2 It is of great scientific value to extend the GW search to other frequencies, just as has been the case for the exploration of the EM spectrum. The levitated sensor detector (LSD) is a 1 m tabletop scale high frequency (< 10 kHz) gravitational wave detection experiment currently under construction at Northwestern University.3 It will serve as a 1 m prototype for future generations of levitated mass based instruments. The LSD sensitivity has more favorable frequency scaling at these frequencies compared to laser interferometer detectors such as LIGO and VIRGO due to different limiting noise factors, the LIGO free spectral range, and the fact that the LSD is a resonant sensor. The LSD is sensitive to GWs from binary coalescence of sub-solar-mass primordial black holes and as-yet unexplored new physics in the high-frequency GW window, such as the annihiation of gravitationally bound states of the QCD axion by black hole superradiance. Many promising experiments and techniques exist for probing the GW spectrum below the LIGO frequency band; they include pulsar timing arrays,4, 5 atomic clocks and other interferometers,6, 7 LISA,8, 9 and DECIGO.10 There are also a number of proposals, experiments and initial bounds set above the LIGO frequency band, largely over 100 MHz.11–18 Fewer established methods to systematically probe the kHz-MHz part of the GW spectrum, where a variety of interesting sources could exist. At Northwestern, we are constructing a compact Michelson interferometer configuration with Fabry-P´erot arms as shown in Figure 3, designed to work in the 10-100 kHz band. In the medium and long term, a multi index dielectric stack will be suspended at an anti-node of the standing wave inside each Fabry-P´erot arm. In the short term, this is likely to be a disc or disc like object (discussed in sections 2 and 2.2) — with which a degree of experimental success has already been had. A second laser is used to read out the position of the object as well as cool it along the cavity axes.19

SOGRO — Terrestrial full-tensor detector for mid-frequency gravitational waves

A superconducting tensor detector for mid-frequency gravitational waves: its multi-channel nature and main astrophysical targets

High frequency gravitational wave detection with optically levitated nanoparticles: an update on LSD (levitated sensor detector)

Gravitational wave detection with optical lattice atomic clocks

A New Method for Gravitational Wave Detection with Atomic Sensors

Gravitational Wave Measurement in the Mid-Band with Atom Interferometers

Gravitational Wave Detection with Photometric Surveys

Status of advanced ground-based laser interferometers for gravitational-wave detection

A cryogenic silicon interferometer for gravitational-wave detection

The next detectors for gravitational wave astronomy

Probing nontensorial gravitational waves with a next-generation ground-based detector network

Laser Interferometer Gravitational Wave Detectors—the Challenges

Mesoscopic interference for metric and curvature & gravitational wave detection

Unveiling the gravitational universe at mu-Hz frequencies

A Superconducting Levitated Detector of Gravitational Waves

Asteroids for $μ$Hz gravitational-wave detection

Mid-band gravitational wave detection with precision atomic sensors

Gravitational Wave Detection with Relative Astrometry using Roman's Galactic Bulge Time Domain Survey

Comparing advanced-era interferometric gravitational-wave detector network configurations: sky localization and source properties

Beyond the Long Wavelength Approximation: Next-generation Gravitational-Wave Detectors and Frequency-dependent Antenna Patterns