Abstract:Zr2SB,Hf2SB,Zr2SeB,Hf2SeB,and Hf2TeB are all recently discovered S-group elements containing MAX-phase borides,which attract much attention since the MAX phase borides are significantly unlike the typical MAX phases.Here,the phase stability,mechanical properties and thermal properties of MAX phase borides(M = Zr,Hf,A = S,Se,Te)were studied by using first principles and"linear optimization method",bond stiffness model and quasi-simple harmonic approximation.The results of the theoretical analysis were consistent with the currently available experimental results.Only M2AB was found to be stable after thermodynamic and intrinsic stability analysis.The shorter M-A bond and M-B bond lengths cause bond stiffness of Hf lineage higher than that of Zr,which also leads to the higher hardness of Hf lineage compound than that of Zr.the A site element goes from S to Se and to Te,the bond lengths of M-B and M-A are gradually increased,which lead to decrease in the elastic modulus.Moreover,the bulk modulus of these compounds is determined by their average chemical bond stiffness.Importantly,the high kmin/kmax(stiffness ratio of the weakest and the strongest bonds)shows that these MAX phases are inherently brittle,different from conventional MAX phase.Including the contribution of lattice vibration(phonon)and electron excitation,the isobaric heat capacity and heat expansion coefficient of M2AB increase rapidly with increasing the temperature below 300 K and then the rise rate gradually decreases,similar to other MAX phases.Lower bond stiffness results in an overall higher TEC of MAX phase borides in the Zr lineage than in the Hf lineage.The TEC values of these compounds in the 300-1300 K interval are consistent with most of the MAX and MAB phases.

Electronic structure, bonding characteristics, and mechanical behaviors of a new family of Si-containing damage-tolerant MAB phases M5SiB2 (M = IVB—VIB transition metals)

Stability Trend, Weak Bonding, and Magnetic Properties of the Al‐ and Si‐containing Ternary‐layered Borides MAB Phases

Phase stability and mechanical property trends for MAB phases by high-throughput ab initio calculations

Effects of Doped Elements (Si, Cr, W and Nb) on the Stability, Mechanical Properties and Electronic Structures of MoAlB Phase by the First-Principles Calculation

First-principles Calculations on Ti2AlB2, Ti3AlB4 and Ti4AlB6, Three Potential New Members of the Orthorhombic MAB Phase

A New Type of Compositionally Complex M5Si3 Silicides: Cation Ordering and Unexpected Phase Stability

Lattice dynamics, Raman and IR vibrations of stable Al/Si‐containing MAB phases: An ab initio and experimental study

Defect behavior and radiation tolerance of MAB phases (MoAlB and Fe2AlB2) with comparison to MAX phases

Phase stability, electronic structure and mechanical properties of molybdenum disilicide: a first-principles investigation

From Mo–Si–B to Mo–Ti–Si–B Alloys: A Short Review

A progress report on the MAB phases: atomically laminated, ternary transition metal borides

Density functional theory insights into ternary layered boride MoAlB

Stabilizing MoB2 with HCP structure in (MoxHf(1‒x)/5Zr(1‒x)/5Ta(1‒x)/5V(1‒x)/5Nb(1‒x)/5)B2 via a high‐entropy strategy

Predictions of Phase Stability and Properties of S-group Elements Containing MAX Borides

Microstructure and Mechanical Properties of Refractory High Entropy (mo0.5nbhf0.5zrti)bcc/m5si3 In-Situ Compound

Novel MAB phases and insights into their exfoliation into 2D MBenes

Phase Stability and Mechanical Property of Newly-discovered Ternary Layered Boride Cr4AlB4

Effects of Zn and Si on the microstructure evolution of the Cr-Al-B MAB phase contained in the periodic layered structure formed in-situ

Structural, elastic, mechanical, electronic, damage tolerance, fracture toughness, and optical properties of Cr–Al–B MAB phases studied by first-principles calculations

Analysis on Phase Stability and Mechanical Property of Newly-discovered Ternary Layered Boride Cr<sub>4</sub>AlB<sub>4</sub>