Abstract:Restrainer is a promising solution for deformation control of isolated systems. The present study comprehensively discusses the behavior, design and potential application of a novel superelastic shape memory alloy (SMA) cable‐restrained laminated natural rubber (SMA‐LNR) bearing. The study commences with a brief introduction of the working principle, and then a quasi‐static test on an individual bearing specimen is presented. A full‐scale shaking table test is subsequently presented, followed by a comprehensive parametric study, leading to preliminary design recommendations. The quasi‐static test shows a two‐stage behavior exhibited by the individual SMA‐LNR bearing, that is, linear flexible behavior at small displacements and restraining stage beyond initial gap. Under dynamic excitations, the SMA cables swayed smoothly with the shear deformation of the bearings, and experienced fracture beyond the maximum considered earthquake (MCE). The restraining effect is strengthened with increasing number of SMA cables, but this is accompanied by an increase in the acceleration response of the superstructure. An earlier engagement of the SMA cables, that is, smaller initial gap, leads to decreases in the bearing deformation. The acceleration responses of the superstructure and the maximum cable strain are not very sensitive to the initial gap. Using an overly small number of SMA cables has limited beneficial effect on bearing deformation control, and may even increase the deformation under certain excitations; therefore, a lower‐bound restraining force offered by SMA cables should be given to ensure an unconditional positive bearing deformation control. Two normalized design parameters and their recommended values are finally proposed to facilitate practical design.

Experimental and numerical investigations on hysteretic response of a multi-level SMA/lead rubber bearing seismic isolation system

Full‐scale shaking table test and numerical analysis of structural frames with SMA cable‐restrained base isolation

Seismic performance of buildings with novel self‐centering base isolation system for earthquake resilience

Response and Performance of A Nonlinear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Shock Excitations

Cyclic behavior of an adaptive seismic isolation system combining a double friction pendulum bearing and shape memory alloy cables

A Direct Displacement-Based Design Procedure for Base-Isolated Building Structures with Lead Rubber Bearings (Lrbs)

Effects of Shape Memory Alloys on Response of Steel Structural Buildings within Near Field Earthquakes Zone

Shaking table tests on seismic behaviors of a single-layer spherical lattice shell with shape memory alloy-controlled friction pendulum bearings

Seismic Behavior of Superelastic Shape Memory Alloy Spring in Base Isolation System of Multi-Story Steel Frame

Utilizing a new self-centering hysteresis model to assess the seismic vulnerability of a long-span cable-stayed bridge equipped with SMA wire-based roller bearings

Experiment investigation and seismic performance evaluation of hybrid isolation bearing with uncoupled compression and shear mechanism

Resilience-based performance and design of SMA/sliding bearing isolation system for highway bridges

Seismic protection of a single-layer spherical lattice shell structure using a separated three-dimensional isolation system

Development of Small-Sized Lead Inserted Laminated Rubber Bearing for Nuclear Component Seismic Isolation

Seismic performance of bridges with novel SMA cable‐restrained high damping rubber bearings against near‐fault ground motions

Seismic behaviour of self-centring hybrid steel frames equipped with SMA plates under mainshock–aftershock sequences

Seismic response control of recentering steel frame with innovative SMA-high damping rubber dampers under sequential earthquakes

Shape memory alloy (SMA)-cable-controlled sliding bearings: development, testing, and system behavior

Experimental investigation on hysteretic properties and applications in beam-column connections of shape memory alloy plates

Seismic Performance of Building with Novel Steel Roller Isolation Bearing: Experimental and Numerical Studies

Experimental, mathematical model, and simulation of a dual-system self-centering energy dissipative brace equipped with SMA and variable friction device