Abstract:To date, there is little information on the degumming technology byStreptomyces lydicus for banana fibers destined for textiles. Furthermore, the retted efficiency and characterization of banana fiber has not yet been found in literatures. In this study, banana fiber (Musa spp. Baxijiao) bio-degumming at laboratory scale with controlled inoculation using selected strain (Streptomyces lydicus) and physicochemical characteristics of retted banana fiber were investigated. The hydrolysis activity of selected strain was conducted by pectin and hemicelluloses culture. Clear zones were visualized on pectin-agar and hemicelluloses-agar plates. Effect of fermentation conditions (temperature, pH, nitrogen source, carbon source and inoculums size) on banana fiber degumming was evaluated based on the content of residual gum and activity of pectin lyase. The results indicated that the optimum degumming medium of strain was pH value 5.0, NH4NO3 4 g/L, wheat bran 10 g and inoculums size 9 mL. After cultivating for 72 h, the activity of pectinase was 75μg/(mL·min), the residual gum of banana fiber was 4.86%, the yield of retted banana fiber was 59.48% (dry weight). Structural and surface analysis of the degumming banana fibers showed a reduction in diameter and changes in surface morphology from that of the raw fibers. The average range of the fiber diameters were approximately 5-10μm, which was lower (p<0.05) than the average size of the fiber bundles before treatment. This reduction in the fiber diameter was due to the dissolution of hemicelluloses and lignin, which was confirmed by the chemical analysis and Fourier Transformation Infrared Spectroscope (FTIR) graphs. The treated fibers showed higher (p<0.05) percentages of cellulose (43.13% to 69.88%) and lower (p<0.05) percentages of hemicelluloses (18.85% to 10.89%), lignin (14.05 to 9.06), pectin (3.43% to 1.91%), and wax (12.24% to 5.77%) compared with untreated fibers. The physical property of fibers were analyzed according to the GB standards(GB5889-1986) and showed an increase in fineness (18.55 to 8.91 tex), and a decrease in break strength (345.37 to 237.37 cN) for the retted fibers. A small weight loss was found from 50 to 100℃, and this loss was primarily attributed to moisture and solvent evaporation or to the low-molecular- weight compounds remained after the isolation procedures. The fiber thermal stability for temperature ranging between 200 and 300℃ was primarily due to the depolymerization of non-cellulose, such as hemicelluloses, and the cleavage of glycosidic linkages of cellulose to form levoglucosan (1,6-anhydro-β-D-glucopyranose) and carbon residues. The decomposition of lignin occurred in the region from 200 to 500℃. The thermogram of the raw banana fiber indicated a greater resistance to degradation in the range of 354 to 527℃ due to the presence of larger amounts of hemicelluloses and lignin, the maximum degradation rate was found during theα-cellulose decomposition of raw and treated banana fibers at 287.45 and 349.04℃ (mass loss = 87.24%), respectively. The thermal analysis showed that the thermal stability of the treated fibers was improved. The XRD pattern of retted fiber, which exhibited an increased crystallinity (11.8% to 52.6%), gives a relatively intense peak at 2θ = 23.87°, and hydrolysis took place preferentially in the amorphous region. In all, the results showed that theStreptomyces lydicusstain had good applying prospects in microbial retting and enzymatic retting of banana fiber.

Banana Fiber Degumming by Alkali Treatment and Ultrasonic Methods

Optimization of banana fibers degumming by high temperature alkaline method and spinning

Process of degumming by chemical for banana pseudostem fibers and characterization of degummed fibers

Process optimization for bio-degumming of banana fiber and characteristics of degummed fibers

Enzyme degumming process of banana pseudostem fibers and characterization of degummed fibers

Extraction, Characterization and Enzymatic Degumming of Banana Fiber

Enhanced Cellulose Extraction from Banana Pseudostem Waste: A Comparative Analysis Using Chemical Methods Assisted by Conventional and Focused Ultrasound

Banana pseudostem fiber: A critical review on fiber extraction, characterization, and surface modification

Optimization for Chemical Degumming Technology of Raw Banana Fiber

Green hydrothermal extraction of banana cellulosic fibers by seawater-assisted media as an alternative to freshwater: physico-chemical, morphological and mechanical properties

Effect of Warm-Water Retting Pretreatment on the Physical Properties of Banana Stem and Its Fibre

An eco-friendly enzymatic treatment to prepare spinnable banana fibers as an alternative to cotton for textile applications

Preparation and Characterization of Cellulose Nanofibers from Banana Pseudostem by Acid Hydrolysis: Physico-Chemical and Thermal Properties

Banana Cellulosic Fiber: A Natural Innovative and Sustainable Bio-Resource for Eco-Friendly Industrial Applications

Integrated pretreatment of banana agrowastes: Structural characterization and enhancement of enzymatic hydrolysis of cellulose obtained from banana peduncle

Enzymatic hydrolysis of cellulose banana stem (alkaline microwave-assisted pre-treatment)

Impact of Sodium Sulfide Treatment on the Mechanical Performance of Banana Fiber

Microstructural, Thermal, and Tensile Characterization of Banana Pseudo-Stem Fibers Obtained with Mechanical, Chemical, and Enzyme Extraction

Preparation and characterization of cellulose nanofibers and nanocrystals from liquefied banana pseudo-stem residue

Study on Biological Materials with the Dehydration Technology and Equipment of Banana Stems

Lignin Degradation Efficiency of Chemical Pre-Treatments on Banana Rachis Destined to Bioethanol Production