Development of microstructure and mechanical properties of TiAl6V4 processed by wire and arc additive manufacturing

Daniel Elitzer,Stefanie Jäger,Clara Höll,Daniel Baier,Rosa Varga,Mathias Göken,Heinz-Werner Höppel,Michael Zaeh

DOI: https://doi.org/10.1002/adem.202201025

IF: 3.6

2022-09-05

Advanced Engineering Materials

Abstract:Wire and Arc Additive Manufacturing (WAAM) has the potential to significantly reduce material waste due to the milling of components made of TiAl6V4 (Ti‐64). To keep up with the market development, this resource‐efficient technology is becoming increasingly important to achieve climate policy goals. Therefore, this study focuses on the influence of different process parameters, such as torch and wire feed speed, but also different gas mixtures on the microstructure and related mechanical properties, as well as on the scalability by investigating single‐ to multi‐layer welded structures. The wire feed speed was found to have a major influence on the geometry and mechanical properties. The use of different process gases, i.e. Argon, Helium and a mixture of 70 % He and 30 % Ar neither significantly affects the microstructure nor the mechanical properties. It was also found that a solution heat treatment followed by an annealing step degrades mechanical properties, while an ordinary stress‐relief heat treatment leads to improved mechanical properties. It is shown that by adapting WAAM‐process and heat treatment parameters, mechanical properties of additively produced specimens can be achieved, that are fully comparable to milled components. This article is protected by copyright. All rights reserved.

materials science, multidisciplinary