Abstract:Highlights RZWQM2-P was tested and validated for clay loam soil using daily discharge and load data. The model performed satisfactorily in predicting hydrology and TP load, but DRP prediction was unsatisfactory. Inability of the model to simulate P loss in subsurface drainage discharge after fertilization event was one of the reasons for the unsatisfactory model performance. Abstract. Phosphorus (P) loss and transport through subsurface drainage systems is a primary focus for addressing harmful algal blooms in freshwater systems. The recent development of the phosphorus (P) routine of the Root Zone Water Quality Model (RZWQM2-P) has the potential to enhance our understanding of the fate and transport of P from subsurface-drained fields to surface water. However, there is a need to test the model under different fertilization, soil, climate, and cropping conditions. The objective of this study was to test the model's performance with daily drainage discharge, dissolved reactive phosphorus (DRP), and total phosphorus (TP) load collected from a subsurface-drained field with clay loam soil. We calibrated RZWQM2-P using two years of measured data. Subsequently, we validated RZWQM2-P using a year and nine months of measured data. We used the Nash-Sutcliffe model efficiency (NSE) and percentage bias (PBIAS) statistics for the RZWQM2-P model evaluation. The results showed that the model performance was “good” (daily NSE = 0.66 and PBIAS = -7.16) in predicting hydrology for the calibration period. For the validation period, the hydrology prediction of the model was “very good” (daily NSE = 0.76), but it had a “satisfactory” underestimation bias (PBIAS = 23.57). The model’s performance was “unsatisfactory” in simulating DRP for both calibration (daily NSE = 0.31 and PBIAS = -61.50) and validation (daily NSE = 0.32 and PBIAS = 43.68) periods. The P model showed “satisfactory” performance in predicting TP load for both calibration (daily NSE = 0.46 and PBIAS = -32.41) and validation (daily NSE = 0.39 and PBIAS = 42.90) periods, although both periods showed “unsatisfactory” percent bias. The underperformance may have been due to the model’s inability to partition fertilizer P into different P pools under high water tables or ponding conditions when using daily data. In conclusion, the RZWQM2-P model performed well for drainage discharge with daily data, but further investigation is needed to improve the P component of the model. Keywords: Field-scale modeling, Nutrient load, Phosphorus modeling, Subsurface drainage, Tile drainage, Water Quality.

Can one‐time calibration of measured soil hydraulic input parameters yield appropriate simulations of RZWQM2?

An Easily Implemented Agro-Hydrological Procedure with Dynamic Root Simulation for Water Transfer in the Crop–soil System: Validation and Application

Simulation of Dynamic Root Growth and Water Transfer in Soil-Crop-atmosphere System

Impact Of Two Calibration Strategies On Flow Simulation In Qiantang River Basin, China

Extending the Integrated Richards Equation Method to New Boundary Conditions: Model Description and Validation

Parameters Sensitivity Analysis and Scaling of RZWQM

Simulating Hydrologic Cycle and Crop Production in a Subsurface Drained and Sub-Irrigated Field in Southern Quebec Using RZWQM2

Calibration of Hybrid-Maize Model for Simulation of Soil Moisture and Yield in Production Corn Fields

Calibration and Validation of RZWQM2-P Model to Simulate Phosphorus Loss in a Clay Loam Soil in Michigan

Impact of calibrating a low-cost capacitance-based soil moisture sensor on AquaCrop model performance

Evaluating RZ-SHAW Model for Simulating Surface Runoff and Subsurface Tile Drainage under Regular and Controlled Drainage with Subirrigation in Southern Ontario

Calibration of an agricultural-hydrological model (RZWQM2) using surrogate global optimization

AquaCrop—The FAO Crop Model to Simulate Yield Response to Water: III. Parameterization and Testing for Maize

Simulating nitrate-nitrogen concentration from a subsurface drainage system in response to nitrogen application rates using RZWQM2

Modeling Soil Water Content and Crop-Growth Metrics in a Wheat Field in the North China Plain Using RZWQM2

Simulation of Water Balance in a Maize Field under Film-Mulching Drip Irrigation

Comparison of RZWQM2 and DNDC Model in Simulating Greenhouse Gas Emission, Crop Yield and Subsurface Drainage

Calibration and Validation of AQUACROP and APSIM Models to Optimize Wheat Yield and Water Saving in Arid Regions

Calibration, testing and application of the AquaCrop model for bean crop under irrigation regimes

Simulating Maize Productivity under Selected Climate Smart Agriculture Practices Using AquaCrop Model in a Sub-humid Environment

Performance Assessment of the AquaCrop Model for Film-Mulched Maize with Full Drip Irrigation in Northwest China