Abstract:Shotcrete shrinkage and cracking are getting more threatening due to its high content of cementitious materials, small aggregate particle size and a large amount of accelerator, which poses a great threat to the construction safety of engineering structures. This paper studies the volume stability of cement mortar with different contents of fly ash (FA) and granulated blast furnace slag (GBFS) (10%/20%/30%) under the condition that the dosage of alkali liquid accelerator is 4% and that of the alkali-free liquid accelerator is 7%. This work is designed to provide a guidance for the basic research and practical application. By comparing the autogenous shrinkage, drying shrinkage, mass loss caused by drying condition, and internal humidity change of drying condition of cement mortar within 180 days of age. Combined with MIP analysis, XRD hydration product analysis, and SEM hydration product morphology analysis, the results show that both fly ash and granulated blast furnace slag can reduce the autogenous shrinkage and drying shrinkage of cement mortar mixed with accelerator to a certain extent, and the shrinkage reduction effect of FA is more prominent. The reduction effect of GBFS is more obvious at high dosages. Adding FA and high content of GBFS can increase the mass loss of cement mortar under drying shrinkage conditions. The high content of mineral admixtures will exacerbate the rate of decrease in the internal humidity of the cement mortar. The reasons for the reduction of autogenous shrinkage and drying shrinkage of cement mortar mixed with accelerators due to the addition of FA and GBFS are: the early activity of the two mineral admixtures is low, and the hydration process is slow. And the reduction of pore size with the range of 5-50nm leads to the reduction of capillary tensile stress and the weakening of the driving force for shrinkage deformation. Among them, the shrinkage reduction effect of fly ash is more pronounced. Therefore, mineral admixture can be used to replace a certain amount of cement in actual shotcrete construction, so as to increase the volume stability of shotcrete.

Evaluating the strength development of mortar using clinker fine aggregate with a combination of fly ash and its inhibitory effects on alkali–silica reaction and delayed ettringite formation

Verification of the mutually complementary effect of fly ash and clinker aggregate on the strength, heat of hydration, and alkali-silica reaction

Influence of Cement Replacement with Fly Ash and Ground Sand with Different Fineness on Alkali-Silica Reaction of Mortar

Long-term strength and durability performance of eco-friendly concrete with supplementary cementitious materials

Effect of Reduced Fineness of Fly Ash Used on the Alkali–Silica Reaction (ASR) of Concrete

Effect of High Calcium Fly Ash, Ladle Furnace Slag, and Limestone Filler on Packing Density, Consistency, and Strength of Cement Pastes

Influence of fly ash and granulated blast furnace slag on autogenous shrinkage and drying shrinkage of cement-based materials mixed with alkali accelerator and alkali-free accelerator

Investigation of Low-Calcium Circulating Fluidized Bed Fly Ash on the Mechanical Strength and Microstructure of Cement-Based Material

Inhibitory mechanism of fly ash on alkali-silica reactivity of siliceous rock fine aggregate: A case study of Yangxi concrete dam

Alkali-Silica Reaction and Residual Mechanical Properties of High-Strength Mortar Containing Waste Glass Fine Aggregate and Supplementary Cementitious Materials

Influence of Calcined Flue Gas Desulfurization Gypsum and Calcium Aluminate on the Strength and AFt Evolution of Fly Ash Blended Concrete under Steam Curing

Effects of Using Cold Bonded Coarse and Fine Calcined Attapulgite Lightweight Aggregates on the Performance Properties of Microsilica and Fly Ash Blended Concretes

Comparative Analysis of Woody Biomass Fly Ash and Class F Fly Ash as Supplementary Cementitious Materials in Mortar

Use of Off-ASTM Class F Fly Ash and Waste Limestone Powder in Mortar Mixtures Containing Waste Glass Sand

PROPERTIES OF CEMENT-FLY ASH MIXTURES WITH SUBSTANDARD FLY ASH AS A PARTIAL CEMENT AND FINE AGGREGATE REPLACEMENT

Prediction of compressive strength development for blended cement mortar considering fly ash fineness and replacement ratio

Performance Characteristics of Self-compacting Concrete Containing Lateritic Fine Aggregate as a Partial Replacement to Natural River Sand

Mechanical and microstructural performances of fly ash blended cement pastes with mixing CO2 during fresh stage

Rheology of Cement Pastes with Siliceous Fly Ash and the CSH Nano-Admixture

Evaluating Durability: A Comparative Study on the Influence of Fly Ash and Silica Fume in Potassium Magnesium Phosphate Cement Mortar

Effect of steel slag powder, fly ash, and silica fume on the mechanical properties and durability of cement mortar