The Binding of Micellar Lipids to Chitosan 1
Abstract:The lipid binding capacity of chitosan (partially deacetylated chitin) was determined with respect to micellar solutions of bile salts, dodecyl sulfate, natural ox bile and an artificial mixed microemulsion. The stoichiometry was determined following the separation of the solid phase by filtration or centrifugation. The major variables in the extent of binding were the pH and ionic strength, suggesting that the interactions are mainly of ionic nature. It is noteworthy that under optimal conditions chitosan could bind, i,e., coprecipitate, with 4-5 times of its weight with all the lipid aggregates tested, These results have a bearing on the nutritional and pharmacological applications of chitosan. The analyses of the components from the precipitates with microemulsion and ox bile show a significant selectivity of binding caused by hydrophobic interactions. Lipids 18:714-719, 1983. The interest in the polysaccharide chitosan (1), which is obtained from chitin by deacetylation, has recently spread into the field of nutrition and food technology. The patent of Yoshida and Yamashita (2) claims chitosan as a binder for pelletizing fertilizers and feeds. The powder of the commercially available free chitosan base was shown by Sugano et al. (3) to induce hypocholesterolemic properties in rats. Nagyvary and co-workers (4) have reported that the water-soluble chitosan acetate is superior to pectin as a general hypolipidemic agent. The promise of chitin and chitosan as an additive to bread was pointed out most recently by Knorr (5), who was concerned mainly with food functionality. Although chitosan is believed to be of low toxicity (6), very little is known of its interactions with nutrients. Obviously, many properties of chitosan are predictable from its polycationic macromolecular structure. The rationale for fatty acid binding must be viewed as quite compelling. This is evidenced from a patent (7) being awarded for the application of chitosan as a lipid binder food additive in the absence of any biological or quantitative in vitro measurements. Since the major action of chitosan is expected to be on lipid absorption and metabolism, the interactions with individual lipids and their physiological combinations will have to be quantitated. In this paper, we report on the stoichiometry of the precipitation resulting by mixing chitosan acetate with t Presented in part at the 64th annual meeting of the Fed. Am. Soc. Exp. Biol., Anaheim, CA, April 1980, and also in partial fulfillment of the requirement for the degree of Master of Science by J. L. Nauss, Texas A&M University (1979). 2 I.L. Nauss is with the U.S. Army, 95th Chem. Co. APO, NY 09169. *To whom correspondence should be addressed. bile salts and their micelles under a variety of conditions. M A T E R I A L S A N D METHODS The chitosan used in this study was donated by Dr. Q. Peniston, Kypro Co. It was a low viscosity grade preparation with an average molecular weight of 80,000. The chitosan was dissolved in 4% acetic acid, and then filtered through cheesecloth and freeze-dried. From elemental analysis, the average residue weight was established to be 219, i.e., the degree of deacetylation was ca. 90%. A sample of this preparation was dissolved in the appropriate buffer at 1.3 mg/ml, representing 1.0 mg/ml of free chitosan base. The sodium salts of dodecyl sulfate (i.e., lauryl sulfate), cholic, glycocholic and taurocholic acids were obtained from Sigma Chemical Co. (St. Louis, MO) and used without further purification. Lecithin from egg yolk was purified by alumina chromatography according to Singleton et al. (8). The readioactive compounds, [4-14C]cholesterol, [24-14C]taurocholate and glycerol tri[9,10(n)-3H]oleate were purchased from Amersham-Searle Co. (Des Plaines, IL). [3 H] Oleic acid was prepared from the triolein by hydrolysis in alcoholic KOH, followed by acidification with dilute HCI and extraction with ether. Questran and cholestyramine were a gift of Dr. K. W. Wheeler (Mead Johnson Pharmaceuticals). Oleic acid was a product of Matheson, Coleman and Bell Co. (Norwood, OH). Bovine gall bladder bile was provided by Dr. T. R. Dutson, Texas A&M University. The two buffer systems used in the binding experiments were 0.01 and 0.05 M imidazoleHCI (pH 6.8) and 0.05 M sodium acetate (pH 4.5). The ionic strength varied between 0.01 LIPIDS, VOL. 18, NO. 10 (1983)
Materials Science,Chemistry