Abstract:Induction heating has been widely applied in the energy and manufacturing industry for its energy-saving, low-cost, local high-efficiency heating, and noncontact benefits. However, the energy efficiency of the induced magnetic field is normally limited for the magnetic scattering effect. To improve the energy and hence heating efficiency, a focused induction heating method (FIHM) has been proposed in this work by using the conical ferrite to focus inner magnetic of the coil. Meanwhile, a numerical model has been established to predict the electromagnetic and thermal distribution during the FIHM process. Traditional induction heating head and two focused induction heating heads (solid ferrite head and drilled-ferrite head) are compared to reveal the influence mechanism of different induction heating heads on the soldering of the pin-through-hole. The results show that the FIHM with drilled-ferrite head can improve the heating efficiency significantly by approximately 6.5-fold when compared to traditional induction heating, leading to a corresponding outstanding temperature increase over 296 degrees C within 1.5 s. Furthermore, the detailed effect mechanism for the six structural parameters of the FIHM on the temperature and magnetic field is studied. This study finds that the distance from the ferrite to the tin ring has the most significant effect, causing a temperature difference of about 560 degrees C. Finally, all these findings have been validated by the soldering experiments, and robust interconnection of deep pin-through-hole joints has been achieved through FIHM without voids. The work provides a theoretical basis and practical guidance for induction heating techniques with excellent electromagnetics and engineering application potential.

Study on the Uniformity of Temperature Distribution of Transverse Flux Induction Heating Based on a New Magnetic Pole

A Study on the Method of Temperature Distribution Control in Electromagnetism Induction Heating

Design and Test Performance of 2g Pancake Coils for Hts Dc Induction Heater Prototype

A novel method improving the temperature uniformity of hot-plate under induction heating

Selection of heating object's position in electromagnetic induction heating

Homogeneous single-coil induction heating achieved by structure design

Temperature Field Optimization of Nano-Magnetic Fluid Hyperthermia Device

Effects of induction heating coil parameters on the temperature field of the tested subjects

Analysis and Optimization of Induction Heating Processes by Focusing the Inner Magnetism of the Coil

Experimental and Numerical Study of a DC Induction Heater Prototype with an Adjustable Air Gap Structure

Temperature Field Distribution Optimization Of Mfh For Cancer Therapy

Temperature-uniformity study on transverse flux induction heating applied to rapid PCR

Numerical Simulation of the Moving Induction Heating Process with Magnetic Flux Concentrator

Magnetohydrodynamic flows and heat transfer in a twin-channel induction heating tundish

STUDY ON TEMPERATURE FIELD INDUCED IN HIGH FREQUENCY INDUCTION HEATING

Design and Operating Characteristics Analysis of HTS Magnets for Dipole-Type DC Induction Heating

The Investigation of Round Billet Temperature and Magnetic Field Distribution and Variation During Induction Heating Process

Modeling And Simulation Of Induction Heating With Magnetic Flux Concentrator

Analysis of a novel rational heating device by using permanent magnets

Simulation Analysis and Experimental Investigation of the Iron-Core Cup-Shaped Transverse Magnetic Field Contact