Abstract:The glycerol generated as a by-product in the production of biodiesel could be used as a renewable raw material to economically promote the production process. The catalytic conversion of glycerol to a product with higher added value, such as glycerol carbonate, has attracted great interest in the chemical, pharmaceutical, and lithium battery industries, among others, due to its low toxicity, hydration capacity, and biodegradability. Layered-double hydroxide (LDH) materials, the precursors of the catalysts, were synthesized by a direct coprecipitation method to incorporate a third metal ion in addition to magnesium and aluminum ions. This method is the easiest regularly applied technique to design these low cost anionic nanoclay. The atomic percentage of Cu, Zn, or Ni incorporated was 15% of the Mg load in the material. The synthesis atomic ratio, (M 2+ +Mg 2+ )/Al 3+ had a constant value of 3, where M represents the transition metal incorporated. LDHs produced the corresponding mixed metal oxides by thermal decomposition. These materials have excellent properties for reactions catalyzed by the basic sites, high surface area, homogeneous cation dispersion, and thermal stability. The physicochemical material properties were characterized by XRD, N 2 sorption, MP-AES, TPD-CO 2 , SEM, and XPS. The mixed oxides were evaluated in the catalytic conversion of glycerol to glycerol carbonate. The addition of Cu, Ni, or Zn to the matrix of Mg and Al produced changes in its physicochemical properties and mostly in the catalytic activity. X-ray diffractograms of LDHs showed the typical characteristic structure of layers even with metallic ions of Cu, Ni, or Zn incorporated, because their ionic radii are similar to that of the Mg ion, 0.69, 0.73, and 0.74 Å, respectively. The obtained mixed oxides showed a high catalytic activity towards the conversion of glycerol to glycerol carbonate under mild reaction conditions, a 1:2 ratio of glycerol:ethylene carbonate and solvent free. Relative yields higher than 80% were obtained, attributable to an adequate distribution of basicity and textural parameters. The catalysts were used in successive reaction cycles without significant loss of activity.

Modification g‐C3N4 by MgO and its application for glycerol carbonate synthesis from glycerol and dimethyl carbonate

Structural study of mixed metal oxide catalysts comprising Mg, Ca, and Al used for upgrading biodiesel byproduct glycerol to glycerol carbonate

Synthesis and Application of Noble Metal Nanocatalysts Supported on MgAl2O4 in Glycerol Dry Reforming Reaction

CO 2 reforming of biodiesel-waste glycerol on nanostructure Ni-SiO 2 .MgO catalysts for syngas production: Influence of the catalyst chemical composition

Etherification of glycerol into short-chain polyglycerols over MgAl LDH/CaCO3 nanocomposites as heterogeneous catalysts to promote circular bioeconomy

Layered double hydroxides modified by transition metals for sustainable glycerol valorization to glycerol carbonate

Production of glycerol carbonate from glycerol and carbon dioxide using metal oxide catalysts

Enhanced Biomass-Derived Glycerol Conversion to Syngas in the CO 2 Reforming Process: Influence of the Nickel Loading Method on Physicochemical Properties and Catalytic Performance

Catalytic Performance of Li/Mg Composites for the Synthesis of Glycerol Carbonate from Glycerol and Dimethyl Carbonate

Mixed oxides from calcined layered double hydroxides for glycerol carbonate production to contribute to the biodiesel economy

Transformation of CO2 with Glycerol to Glycerol Carbonate over ETS-10 Zeolite-Based Catalyst

Syngas production from CO2 reforming of glycerol by mesoporous Ni/CeO2 catalysts

Comparative study of catalytic conversion of glycerol, a by-product of transesterification, to cyclic hydrocarbons using MCM-22, ZSM-5 and alumina

Oligomerization of glycerol on layered sodium silicate catalysts

Glycerol carbonate synthesis via transesterification of enriched glycerol and dimethyl carbonate using a Li-incorporated MCM-41 framework

Transesterification of Glycerol to Glycerol Carbonate over Mg-Zr Composite Oxide Prepared by Hydrothermal Process

A Green Approach to Obtaining Glycerol Carbonate by Urea Glycerolysis Using Carbon-Supported Metal Oxide Catalysts

Kinetic studies on the synthesis of fuel additives from glycerol using CeO2–ZrO2 metal oxide catalyst

Hydrogenolysis of Glycerol over NiCeZr Catalyst Modified with Mg, Cu, and Sn at the Surface Level

Tuning catalytic performance: comparative study of magnesium–strontium mixed oxide catalysts for glycerol carbonate synthesis

Ni Supported on MgO Modified Attapulgite As Catalysts for Hydrogen Production from Glycerol Steam Reforming