Abstract:Alvarez-type Drift Tube Linacs (DTLs) are commonly adopted to accelerate the proton or heavy ion beam with the speed range about 0.04 similar to 0.4 times of the light speed in vacuum. Acquisition of appropriate frequency and distribution of the electromagnetic field, and the field stability inside the Alvarez-type DTL cavity are essential to achieve good beam characteristics. The field requirement can be achieved through tuning by tuners and post couplers when the cavity is off-line. The field stability of cavity is usually measured by the tilt sensitivity and the minimum frequency interval between the operation mode and the nearest neighbor mode. The frequency interval will increase with the reduction of the number of the acceleration units (cells) inside the cavity, which is beneficial to fulfill the tilt sensitivity requirement. If the field stability condition is naturally satisfied, the post couplers inside the DTL cavity are not needed, and the cavity frequency and field distribution can be tuned merely by tuners. In this paper, the tuning method based on the pseudo-inverse matrix is applied to the Alvarez-type DTL cavity without post couplers in Xi'an 200 MeV proton application facility (XiPAF). The method is improved by an expanded matrix algorithm and the tuning process is optimized to expedite the iteration during the tuning. The XiPAF DTL cavity has 23 cells and 5 tuners. By adjusting the insertion depths of the tuners, the tuning was achieved in merely one round of iteration. After tuning, the relative error of the peak field distribution and resonant frequency of the cavity reached to within +/- 3% and 325 +/- 0.007 MHz (25 degrees C, vacuum), respectively. It was verified that the field stability meets the requirement from the physical design both before and after tuning.

Refined betatron tune measurements by mixing beam position data

Tune Evaluation From Phased BPM Turn-By-Turn Data

Real-Time Betatron Tune Correction With the Precise Measurement of Magnet Current

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Beam Instrumentation System Optimization for Top-up Operation in SSRF

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

Incoherent tune measurement of an ion storage ring using single ions

TEST OF THE TUNE MEASUREMENT SYSTEM BASED ON BBQ AT HLS-II STORAGE RING *

Calibration of beam position monitors for high energy accelerators based on average trajectories

Tracking Simulations Near Half-Integer Resonance at PEP-II

Linear coupling of transverse betatron oscillations: Dynamic stability and invariants of motion

Beam Position Monitors As Precise Phase Pickups for Beam Energy Measurement at the Compact Pulsed Hadron Source

A PROPOSAL FOR THE MEASUREMENT OF THE REAL EMITTANCE OF THE BEAM IN CYCLIC ACCELERATORS

Synchrotron radiation based beam diagnostics at the Fermilab Tevatron

Button-Type Beam Position Monitor Development for Fourth-Generation Synchrotron Light Sources: Numerical Modeling and Test Bench Measurements

Measurement and modeling of electron-cloud-induced betatron tune shifts at the Cornell Electron-positron Storage Ring test accelerator

Dedicated beam position monitor pair for model-independent lattice characterization at NSLS-II

RF measurement and tuning for an Alvarez-type drift tube linear accelerator without post couplers

Tuning of CLIC Accelerating Structure Prototypes at CERN

Classical and modern power spectrum estimation for tune measurement in CSNS RCS