Abstract:It is common practice to describe the coordination of metal atoms in a binding configuration with their nearest neighbors in terms of oxidation state, a measure by which the number of electrons redistributed between atoms forming chemical bonds. In XPS terms, change to an oxidation state is commonly inferred by correlating photoemission signal with binding energy. The assumption, when classifying photoemission signals into distinct spectral shapes, is that a distribution of intensities shifted to lower binding energy is evidence of a reduction in oxidation state. In this Insight note, we raise the prospect that changes in photoemission peak shape may occur without obvious changes, determined by XPS in stoichiometry for a material. It is well known that TiO 2 measured by XPS yields reproducible Ti 2p photoemission peaks. However, on exposing TiO 2 to ion beams, Ti 2p photoemission evolves to complex distributions in intensity, which are particularly difficult to analyze by traditional fitting of bell‐shaped curves to these data. For these reasons, in this Insight note, a thin film of TiO 2 deposited on a silicon substrate is chosen for analysis by XPS and linear algebraic techniques. Alterations in spectral shapes created from modified TiO 2 , which might be interpreted as the change in oxidation state, are assessed in terms of relative proportions of titanium to oxygen. It is found through detailed analysis of spectra that quantification by XPS, using procedures routinely used in practice, is not in accord with the typical interpretations of photoemission shapes. The data processing methods used and results presented in this work are of particular relevance to elucidating fundamental phenomena governing the surface evolution of materials‐enabled energy processes where cyclic/non‐steady usage changes the nature of bonding, especially in the presence of contaminants.

Experimental studies of electron affinity and work function from titanium on oxidised diamond (100) surfaces

Characterization of the Surface Oxygen-Diffusion Zone of the Thermally Oxidized Titanium

Experimental Studies of Electron Affinity and Work Function from Aluminium on Oxidized Diamond (100) and (111) Surfaces

Surface Characterization of Thermally Oxidized Titanium Alloys

Work function and electron affinity of the fluorine-terminated (100) diamond surface

Residual Stresses And Debonding Of Diamond Films On Titanium Alloy Substrates

The Interface Diffusion and Chemical Reaction Between a Ti Layer and a Diamond Substrate

Study of the metallization and interface reaction between diamond film and Ti layer by AES

Electron affinity of plasma-hydrogenated and chemically oxidized diamond (100) surfaces

Effect of ultraviolet and x-ray radiation on the work function of TiO2 surfaces

Oxygen-terminated diamond: insights into the correlation between surface oxygen configurations and work function values

A theoretical study on the surface reaction of tetrakis(dimethylamino)titanium on titanium oxide

Surface Analysis Insight Note: Observations relating to photoemission peak shapes, oxidation state, and chemistry of titanium oxide films

Surface Modification and Alloying of Aluminum and Titanium Alloys with Low-Energy, High-Current Electron Beams

Interactions of low energy reactive ions with surfaces. IV. Chemically bonded diamond‐like films from ion‐beam deposition

Surface treatment of titanium alloys for the x-ray diffraction study

Atomic Scale Study Of Surface Orientations And Energies Of Ti2o3 Crystals

Stability and Work Function Ofticxn1−xalloy Surfaces: Density Functional Theory Calculations

XPS characterisation of surface modified Ni-Ti shape memory alloy

Atomic scale study of surface orientations and energies of Ti<sub>2</sub>O<sub>3</sub> crystals

Photoemission Fingerprints for Structural Identification of Titanium Dioxide Surfaces