Abstract:The general frame of the present study falls under the umbrella of ongoing research and innovation in wind energy technology to improve the efficiency and reliability of vertical-axis wind turbines (VAWTs) in terms of design and control. While blade pitching is foreseen as a solution to minimize boundary layer separation and maximize the lift force during the entire cyclic blade operation (effectively enhancing the performances of VAWTs), conclusive research on active blade pitching mechanisms in low wind speed regions is limited because of the 3D complex aerodynamic around VAWT blades. The paper reports a holistic study on active blade pitching solutions to enhance the performance of H-rotor Darrieus VAWTs for different turbine design parameters, i.e., geometrical (different number and airfoil thickness, and solidity) under several operational conditions (Reynolds number ( Re ), and tip speed ratio (TSR)). In this study, a variable blade pitching technique, adapted for periodic variation of the angle of attack , is incorporated in a high-fidelity two-dimensional VAWTs transient Computational Fluid Dynamics (CFD) model to eliminate the dead band of small-scale wind turbines operating at low wind speed regions and increase the performance coefficient Cp at different TSRs. Sliding mesh and remeshing to capture the blade pitching are used to manage the rotor rotation. The CFD model is validated against experimental data from the literature. The results indicate that the local widening of the angle of attack (AoA) for each NACA0015 airfoil produces a Cp of 0.44, which represents 81% enhancement in the Cp at TSR of 1.5. Moreover, the study shows that increasing the number of blades or extending the blade chord length can eliminate the dead band of wind turbines. Furthermore, the maximum possible torque for 3- and 4-bladed rotor designs is achieved using the variable pitching mechanism.

An Experimental Study on a Wind Turbine Rotor Affected by Pitch Imbalance

Reduction and analysis of rotor blade misalignments on a model wind turbine

RESEARCH ON THE LOAD CONTROL OF WIND TURBINES BASED ON INDIVIDUAL PITCH TECHNOLOGY

Development and Experimental Validation of a Model-Based Balancing Prediction Method for Bowed Rotor

Optimal blade pitch control for enhanced vertical-axis wind turbine performance

Individual pitch controller characteristics analysis and optimization under aerodynamic imbalanced loads of wind turbines

Flow analysis and sensitivity study of vertical-axis wind turbine under variable pitching

Multi-fidelity Analyses of Rotor Loads of Floating Offshore Wind Turbines with Wind/Wave Misalignment

Wind Turbine Geometrical and Operation Variables Reconstruction from Blade Acceleration Measurements

Numerical Simulations of the NREL Phase VI Wind Turbine with Low-Amplitude Sinusoidal Pitch

Dynamic Characteristics and Enhanced Performance of a Novel Wind Turbine Rotor Analyzed Via Experiments and Numerical Simulation

Performance Analysis and Optimization of a Vertical-Axis Wind Turbine with a High Tip-Speed Ratio

Rotor imbalance detection and diagnosis in floating wind turbines by means of drivetrain condition monitoring

Aerodynamic Performance of a Small-Scale Tilt Rotor: Numerical Simulation and Experiment in Steady State

Wind tunnel and numerical study of a small vertical axis wind turbine

Experimental Investigation of the Performance and Wake Effect of a Small-Scale Wind Turbine in a Wind Tunnel

Torque Smoothing Control of Wind Turbine Generator System Using Individual Pitch Control

Rotation improvement of vertical axis wind turbine by offsetting pitching angles and changing blade numbers

A comparison of dynamic inflow models for the blade element momentum method

An experimental study of rotational effects on modal parameters of rotating wind turbine blades

Experimental and Numerical Investigation of Tubercles and Winglets Horizontal Axis Wind Turbine Blade Design