Abstract:The plasmonic phase‐change material In3SbTe2 can be reversibly switched from an amorphous dielectric to a crystalline metallic state. Infrared emissivity control by patterning a grating absorber metasurface for different polarizations, which can be only seen in the long‐wave infrared (LWIR) regime, is demonstrated. Additionally, a 1 × 1 cm2 metasurface is fabricated with enhanced emissivity to display an apparent local temperature pattern. Metasurfaces with perfect infrared absorption promise integrated filters and compact detector elements with narrowband thermal emission. Phase‐change materials (PCMs) are prime candidates for active, non‐volatile absorption tuning. Commonly, the response of the entire metasurface is tuned, while local adaptions remain elusive. In this work, flexible encoding of different absorption/emission properties within a metasurface is shown. The plasmonic PCM In3SbTe2 (IST) is employed to obtain control over the emissivity by patterning an adaptable grating absorber metasurface. Using a commercial direct laser writing setup, the IST is locally switched from an amorphous dielectric into a crystalline metallic state, and cm‐sized stripe gratings are written above a reflecting mirror. Modification of already written patterns is demonstrated by changing the laser power and thus the IST stripe width to encode different polarization‐sensitive patterns with nearly perfect absorption into the same metasurface. Finally, an apparent local temperature pattern due to the large‐area emissivity shaping metasurface is measured with a conventional thermal camera. The results pave the way towards low‐cost, large‐area, and adaptable patterning of metasurfaces with wavelength and polarization‐selective perfect absorption, enabling applications like enhanced thermal detection, infrared camouflage, or encoding anti‐counterfeiting symbols.

Adaptive thermal camouflage using sub-wavelength phase-change metasurfaces

Structured thermal surface for radiative camouflage

3D Printed Meta‐Helmet for Wide‐Angle Thermal Camouflages

A Switchable Metasurface Between Meta-Lens and Absorber

Spin-dependent switchable metasurfaces using phase change materials.

Dynamic Thermal Emission Control Based on Ultrathin Plasmonic Metamaterials Including Phase‐Changing Material GST

Multi-band middle-infrared-compatible camouflage with thermal management via simple photonic structures

Tunable Metasurfaces Based on Phase-Change Materials

Multispectral Camouflage for Infrared, Visible, Lasers and Microwave with Radiative Cooling.

Phase change plasmonic metasurface for dynamic thermal emission modulation

Reconfigurable and Polarization‐Dependent Grating Absorber for Large‐Area Emissivity Control Based on the Plasmonic Phase‐Change Material In3SbTe2

Deep Learning-Based Metasurface Design for Smart Cooling of Spacecraft

A Dynamic Thermal Camouflage Metadevice with Microwave Scattering Reduction

Optimization of a Ge2Sb2Te5-Based Electrically Tunable Phase-Change Thermal Emitter for Dynamic Thermal Camouflage

Reconfigurable phase-change metasurfaces from efficient wavefront manipulation to perfect absorption

Dynamic nonlocal metasurface for multifunctional integration via phase-change materials

Simultaneous solar rejection and infrared emission switching using an integrated dielectrics-on-VO2 metasurface

Visibly Transparent Multi-Functional Camouflage Coating with Efficient Thermal Management

Implementing of infrared camouflage with thermal management based on inverse design and hierarchical metamaterial

Electrically driven reprogrammable phase-change metasurface reaching 80% efficiency

Visibly transparent multifunctional camouflage coating with efficient thermal management