Modeling of solar CPVT system integrated with heat sinks in existence of hybrid nanofluid
M. Sheikholeslami,F. Najafi
DOI: https://doi.org/10.1007/s10973-024-13128-1
IF: 4.755
2024-05-22
Journal of Thermal Analysis and Calorimetry
Abstract:Concentrated photovoltaic thermal (CPVT) systems involving parabolic reflector have been scrutinized in this article. The purpose of using such a concentrated solar system is achieving higher electrical power and greater thermal productivity. The configuration of cooling system is very significant part of designing such CPVT system, and three configurations were utilized in this numerical modeling: (1) smooth duct (case I); (2) sinusoidal duct (case II); and (3) sinusoidal duct equipped with sinusoidal fins (case III). The utilized testing fluid was a mixture of water and hybrid nanoparticles, and homogeneous formulation was utilized for finding the properties of nanomaterial. Two steps for simulations have been considered: (1) finding the distribution of heat flux involving pure radiation within two-dimensional domains and (2) three-dimensional laminar flow of hybrid nanofluid involving all layers of PV. Active variables of present modeling were: concentration of hybrid additives ( φ = 0, 0.04), amplitude ( a = 1, 2 and 4 cm) and pitch ratio ( λ = 0, 4 and 16 mm) of sinusoidal duct; number of fins (NoF = 1, 3); inlet flow rate ( Q = 1, 2, 3 L min −1 ). When sinusoidal duct has been applied in the absence of helical fin, the electrical efficacy elevates about 2.5% with inclusion of hybrid nanomaterial when a = 1 cm and λ = 4 mm. With switching from case I to case II, thermal efficiency augments about 3.5%. In view of overall efficacy, case III has the best performance among various scrutinized configurations. If the third configuration has been utilized, applying more fins makes η th and η ele increase about 0.5% and 0.8, respectively. Increase in Q in existence of one fin leads to augmentation of PEC about 51.38%.
chemistry, physical, analytical,thermodynamics