Abstract:Lithium–sulfur (Li–S) batteries are severely hindered by the low sulfur utilization and short cycling life, especially at high rates. One of the effective solutions to address these problems is to improve the sulfiphilicity of lithium polysulfides (LiPSs) and the lithiophilicity of the lithium anode. However, it is a great challenge to simultaneously optimize both aspects. Herein, by incorporating the merits of strong absorbability and high conductivity of SnS with good catalytic capability of ZnS, a ZnS-SnS heterojunction coated with a polydopamine-derived N-doped carbon shell (denoted as ) with uniform cubic morphology was obtained and compared with the ZnS-SnS2@NC heterostructure and its single-component counterparts ( and SnS2@NC). Theoretical calculations, ex situ XANES, and in situ Raman spectrum were utilized to elucidate rapid anchoring-diffusion-transformation of LiPSs, inhibition of the shuttling effect, and improvement of the sulfur electrochemistry of bimetal ZnS-SnS heterostructure at the molecular level. When applied as a modification layer coated on the separator, the cell with optimized lithiophilicity and sulfiphilicity enables desirable sulfur electrochemistry, including high reversibility of 1149 mAh g–1 for 300 cycles at 0.2 C, high rate performance of 661 mAh g–1 at 10 C, and long cycle life with a low fading rate of 0.0126% each cycle after 2000 cycles at 4 C. Furthermore, a favorable areal capacity of 8.27 mAh cm–2 is maintained under high sulfur mass loading of 10.3 mg cm–2. This work furnishes a feasible scheme to the rational design of bimetal sulfides heterostructures and boosts the development of other electrochemical applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsnano.1c00270?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsnano.1c00270</a>.Additional experimental sections (materials synthesis, characterizations, and DFT calculations); SEM, TEM, XRD, TG, XPS, BET, and XANES characterizations of the samples; CV curves; discharge–charge profiles and cycle performance of various electrodes; in situ Raman tests; optimized geometries of LiPSs; Tables S1–S6: Li+ diffusion rates, EIS fitting, and comparisons of electrochemical performance (<a class="ext-link" href="/doi/suppl/10.1021/acsnano.1c00270/suppl_file/nn1c00270_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Preparation of Fe3O4/FexSy heterostructures via electrochemical deposition method and their enhanced electrochemical performance for lithium-sulfur batteries

Bimetallic sulfides heterostructure efficient adsorption and catalytic of polysulfides for high-performance lithium-sulfur batteries

Carbon-coated Mesoporous Fe 3 O 4 Nanospindles with Interconnected Porosities as Polysulfide Mediator for Lithium-Sulfur Batteries

Ferromagnetic 1D-Fe3o4@c Microrods Boost Polysulfide Anchoring for Lithium–Sulfur Batteries

Dipolar and catalytic effects of an Fe<sub>3</sub>O<sub>4</sub> based nitrogen-doped hollow carbon sphere framework for high performance lithium sulfur batteries

SnS2/SnO2 Heterostructures Towards Enhanced Electrochemical Performance of Lithium-Sulfur Batteries

Self-templating synthesis of prismatic-like N-doped carbon tubes embedded with Fe3O4 as a high-efficiency polysulfide-anchoring-conversion mediator for high performance lithium-sulfur batteries

Rich Heterointerfaces Enabling Rapid Polysulfides Conversion and Regulated Li2S Deposition for High-Performance Lithium-Sulfur Batteries.

Porous Fe2O3 Doped Cathodes for Lithium-Sulfur Batteries

Hypercrosslinked Polymerization Enabled N‐Doped Carbon Confined Fe 2 O 3 Facilitating Li Polysulfides Interface Conversion for Li–S Batteries

Preparation and Application of NiS2/NiSe2 Heterostructure As a Sulfur Host in Lithium-Sulfur Batteries

Fe-MOF Derived Jujube Pit Like Fe3O4/C Composite As Sulfur Host for Lithium-Sulfur Battery

Anchoring Polysulfides and Accelerating Redox Reaction Enabled by Fe‐Based Compounds in Lithium–Sulfur Batteries

Regulating the d-p band center of FeP/Fe2P heterostructure host with built-in electric field enabled efficient bidirectional electrocatalyst toward advanced lithium-sulfur batteries

ZnS-SnS@NC Heterostructure as Robust Lithiophilicity and Sulfiphilicity Mediator toward High-Rate and Long-Life Lithium–Sulfur Batteries

Engineering Oversaturated Fe-N5 Multifunctional Catalytic Sites for Durable Lithium-Sulfur Batteries

Loading Fe3O4 nanoparticles on paper-derived carbon scaffold toward advanced lithium–sulfur batteries

Self-Formed Hybrid Interphase Layer on Lithium Metal for High-Performance Lithium-Sulfur Batteries.

Expediting polysulfide catalytic conversion for lithium-sulfur batteries <i>via in situ</i> implanted ultrafine Fe<sub>3</sub>O<sub>4</sub> nanocrystals in carbon nanospheres

Ferrocene-Promoted Long-Cycle Lithium-Sulfur Batteries

Enhanced Sulfur Transformation by Multifunctional FeS2/FeS/S Composites for High‐Volumetric Capacity Cathodes in Lithium–Sulfur Batteries