Abstract:The use of recycled brick aggregates (RBAs) in concrete could provide sustainable solution in construction industry by reducing the consumption of natural resources and protecting the environment by saving landfill sites. However, the use of RBAs is uncommon due to limited available research studies investigating its mechanical and durability behavior, especially the freeze-thaw (FT) behavior. Despite a few studies on FT resistance of RBA concrete (RBAC), the FT deterioration mechanism in RBAC is not fully understood, particularly at the microscale. This lack of understanding hinders the widespread adoption of RBAC in sustainable construction practices, particularly in cold regions. Therefore, this study investigates the FT deterioration mechanism in RBAC using macro and microscale experiments and proposes a Weibull damage model to accurately describe the damage variation in RBAC. RBAC specimens with different water-cement (w/c) ratios of 0.65, 0.5 and 0.35 and RBA replacement levels of 0%, 25%, 50% and 100% were produced and tested under rapid FT cycles. Surface scaling, mass loss, relative dynamic modulus of elasticity, and compressive strength reduction were evaluated. X-ray computed tomography (XCT) was used to characterize pore structure and microcracking alterations during FT cycles. The results showed that the deterioration of RBAC increased with the increase in RBA replacement level. XCT revealed increased porosity and microcracking within the RBA particles, which was linked to the significant damage observed in RBAC compared to reference concrete. Quantitative analysis of pore size distribution before and after FT cycling revealed a substantial increase in small pores (<1 mm3) in RBAC. The proposed Weibull distribution damage model accurately described the damage variation in RBAC with different w/c ratios. This study provides new insights into multiscale FT deterioration mechanisms affecting RBAC, aiding in optimizing RBAC mix designs to balance sustainability and durability.

The investigation of concrete damage and recycled aggregate properties under microwave and conventional heating

Experimental assessment of microwave heating assisted aggregate recycling from dried and saturated concrete

Thermally Assisted Liberation of Concrete and Aggregate Recycling: Comparison between Microwave and Conventional Heating

Influence of Construction Conditions on Properties of Recycled Concrete

Enhancement Strategies for Recycled Brick Aggregate Concrete Using MICP and EICP Treatments

Stripping of aggregate from mortar in waste concrete heated by microwave: mechanisms of differential-temperature stress and vapor expansion pressure

Characterizations and Quantification of Freeze-Thaw Behaviors of Recycled Brick Aggregate Concrete

Using Microwave Heating to Completely Recycle Concrete

A Fully Coupled Electromagnetic Irradiation, Heat and Mass Transfer Model of Microwave Heating on Concrete

Study on the Performance of Recycled Coarse and Fine Aggregates as Microbial Carriers Applied to Self-Healing Concrete

Study on the Effects of Microwave Heating Time and Power on the Mechanical Properties of Cemented Tailings Backfill

Synergetic recycling of recycled concrete aggregate and waste mussel shell in concrete: Mechanical properties, durability and microstructure

Acoustic emission behavior and damage evaluation of recycled aggregate concrete under compression

Pore size distribution and ITZ performance of mortars prepared with different bio-deposition approaches for the treatment of recycled concrete aggregate

Theoretical investigation of electromagnetic-thermal coupling of double-layer cylindrical concrete under microwave irradiation

Effect of Loading-Induced Damage on Chloride Ingress Behavior of Recycled Aggregate Concrete: A Comprehensive Review

Mechanical Properties and ITZ Microstructure of Recycled Aggregate Concrete Using Carbonated Recycled Coarse Aggregate

Studies on the Thermal-Physical Treatment of Waste Concrete for Use in Lightweight Aggregate Concrete

Enhancing quality and strength of recycled coarse and fine aggregates through high-temperature and ball milling treatments: mechanisms and cost-effective solutions

Improvement in Properties of Concrete with Modified RCA by Microbial Induced Carbonate Precipitation

Effect of brick aggregate on failure process of mixed recycled aggregate concrete via X-CT