Abstract:The fundamental aspects of site preference of alloying elements on sublattice of the strengthen γ′ phase with L12 structure have not been well understood, which hinders the optimized design of advanced Ni-based high-temperature alloys. In this contribution, the temperature- and composition-dependent site occupying preferences of the binary, ternary, and quaternary of Ni3Al-based γ′ phase alloyed with Mi where Mi represents the additional transitional metals Co, Cr, Cu, Fe, Mn, Mo, Re, Ta, Ti, V, or W atoms (arranged in alphabetical order) chosen frequently, were studied using a two-sublattice thermodynamic model (Ni, Al, Mi)1a(Ni, Al, Mi)3c. The site occupying fractions (SOFs) were calculated based on a thermodynamic database established in this work, where the thermodynamic data of the end-members involved were obtained using first-principles calculations and phonon spectrum calculations. The calculated SOFs results show that there is an obvious site preference for stoichiometry binary Ni3Al, and its site configuration changes from (Al)1a(Ni)3c at room temperature to (Al0.9984Ni0.0015)1a (Al0Ni0.9994)3c at 1273 K. For the γ′ phase with the composition 78Ni-26Al-4Mi (atom ratio and xNi/xAl = 3:1), Mo atoms always preferred to occupy the 1a sublattice (Al site), Co, Mn, and Ti atoms always prefer the 3c sublattice (Ni site) in the whole temperature range, while the site preference of Cr, Cu, Fe, Re, Ta, V, or W atom is affected by temperature. For example, when the heat treatment temperature is lower than 700 K, Cr, Cu, Fe, Ta, V, and W atoms occupy the 1a and 3c sublattice randomly, and Re atoms prefer to 3c sublattice, while when the heat treatment temperature is higher than 1273 K, Cr, Cu, and W atoms prefer 3c sublattice, Fe and Ta atoms prefer to 1a sublattice, while all Re atoms occupy the 3c sublattice exclusively, and all V atoms occupy the 1a sublattice exclusively, respectively. Likewise, the site preference of the quaternary system with selective compositions 78Ni-26Al-2 M1-2 M2 was also predicted. Based on calculated SOFs results, the mechanical and thermodynamic properties were studied at the ground state. It has been revealed that Cr, Re, and V doping can improve the microhardness of Ni3Al alloys; in particular, the effect of Cr is extraordinary; and all elements, except Mn, Mo, and Ti, would enhance the bulk modulus of Ni3Al-based γ′ phase, in which Mn have the greatest influence on reducing the bulk and shear modulus, respectively. Furthermore, all the B/G ratios of the computed Ni3Al-based γ′ phase are >1.75, showing inherent ductility. Only Cr doping significantly enhances the Debye temperature of the Ni3Al-based γ′ phase.

Site-dependent mechanical properties of 3d transition metal-doped MnV intrinsic ductile intermetallic: First-principles and data mining study

A First-Principle Study of Monolayer Transition Metal Carbon Trichalcogenides

Effect of Anti-Site Point Defects on the Mechanical and Thermodynamic Properties of MgZn2, MgCu2 Laves Phases: A First-Principle Study

First Principles Studies on the Elastic, Thermodynamic Properties and Electronic Structure of Ti15−xMoxSn Compounds

First-principles Calculations of the Mechanical Properties of Mg2Si Intermetallic Via Ternary Elements Doping

First-principles study of martensitic transformation and magnetic properties of carbon doped Ni–Mn–Sn Heusler alloys

Site Preference of Transition-Metal Elements Additions on Mechanical and Electronic Properties of B2 DyCu-based Alloys

Advanced mechanical properties obtained via transition metals doped in CrFeNi medium entropy alloy

First principles study structural and magnetic properties of Mn doped MgO

First-Principles Calculations of the Mechanical Properties of Doped Cu3P Alloys

First principles calculation to investigate the effect of Mn substitution on Cu site in CeCu3- x Mn x V4O12 (x = 0, 1, 2 and 3) system

First-principles calculations of Ni-(Co)-Mn-Cu-Ti all-d-metal Heusler alloy on martensitic transformation, mechanical and magnetic properties

Site preference of the 3 d transition metal ions in the Mn 4 − x Fe x Nb 2 O 9 compounds as revealed by Mössbauer spectroscopy

First-principles study the mechanical, electronic, and thermodynamic properties of Mg-Al-Mn ternary compounds

Study of structural, elastic, electronic, optical and magnetic properties of Heusler Mn2NiAl: Ab initio calculations

Transition-metal-element Dependence of Ideal Shear Strength and Elastic Behaviors of Γ′-Ni3al: Ab Initio Study to Guide Rational Alloy Design

Uncovering the origin of physical properties associated with magneto-structural transition of Ni-Mn-In- X alloys by ab initio methods

Effect of Transition Metal (TM) Doping on Structural and Magnetic Properties in Hexagonal YMn0.917TM0.083O3 Systems

The site preference and doping effect on mechanical properties of Ni3Al-based γ′ phase in superalloys by combing first-principles calculations and thermodynamic model

First-principles Investigation of 3d Transition Elements in L10 TiAl

Superior Magnetic and Mechanical Property of Mnfe3n Driven by Electron Correlation and Lattice Anharmonicity