Abstract:This study conducted uniaxial compression acoustic emission (AE) tests on four typical rocks with different lithologies, including coal, limestone, gypsum, and shale. In addition to measuring their stress-induced deformation process and associated AE time-varying response, this work emphatically discussed the differences in mechanical properties, fracture modes, spatial-temporal evolution, frequency band energy distribution, and nonlinear characteristics of stress-induced AE signals. According to the results, the AE energy released during the loading process and the total energy at the peak stress are closely related to the rock strength. The main microcracking fractures of coal and limestone are mixed mode with both shear and tensile components, while those of gypsum and shale are mainly tensile axial-splitting failures. The AE locations of those four tested rocks correspond to their macroscopic rupturing morphology respecitively, but with different occurrence times and spatial distributions. Additionally, the stress-induced AE events of coal, gypsum, and shale are relatively less during the pre-peak loading stages, while that of limestone begins to become frequent and reach its maximum in the crack extension damage stage. The AE frequency band energy distribution, calculated by wavelet packet decomposition, of limestone is smaller than coal, gypsum, and shale, suggesting that limestone has a larger microfracture scale than the other three rocks. However, it should be noted that approximately 90% of the energy band distribution of these four lithologies is less than 150 kHz. Besides, the nonlinear Hurst index of AE signals is greater than 0.5 when the specimens are loaded around 99% pre-peak stress. This suggests a long-term correlation between acoustic response and the loading process, with a more pronounced increase in the AE signal during the stage close to the catastrophic failure stage. The above findings provide valuable insights into the failure mechanisms of different rocks, contributing to the theoretical framework for preventing and controlling rock engineering disasters.

Blasting relaxation characteristics of columnar jointed rock mass with AE technology

Damage Evolution of Rocks Containing a Set of Cross-Joints Based on Acoustic Emission Characteristics

A Study on the Vibration Frequency of Blasting Excavation in Highly Stressed Rock Masses

Study on the Stress and Deformation of Surrounding Rock and Support Structure of Super Large Section Tunnels Based on Different Excavation Methods

Investigation on the failure mechanism of the collapse of the columnar jointed basalt in underground cavern

Acoustic emission characteristics and fracture mechanism of sandstone in open-pit mines under different types of cyclic loads

ACOUSTIC EMISSION TEST ON DAMAGE EVOLUTION OF SURROUNDING ROCK IN DEEP-BURIED TUNNEL DURING TBM EXCAVATION

Frequency domain analysis of AE waveforms in rockburst specimens under different stress gradients

Response of Acoustic Emission and Vibration Monitoring Data During Rock Block Collapse in the Tunnel: Small- and Large-Scale Experiments Study

Microseismic Monitoring of Rock Mass Fracture Response to Blasting Excavation of Large Underground Caverns Under High Geostress

Experimental Study on Acoustic Emission Characteristics of Intermittent Jointed Rock Mass under Uniaxial Compression

A method for monitoring acoustic emissions in geological media under coupled 3-D stress and fluid flow

A Study on Triaxial Unloading Test of Columnar-Jointed-Rock-Mass-Like Material with AW Velocity Analysis

Failure modes and excavation stability of large-scale columnar jointed rock masses containing interlayer shear weakness zones

Stress-induced AE varying characteristics in distinct lithologies subjected to uniaxial compression

An experimental study of Lode angle impact on the rock failure procession based on acoustic emission

Acoustic Emission Characteristics of Red Sandstone Specimens Under Uniaxial Cyclic Loading and Unloading Compression

Experimental Study on Acoustic Emission Characteristics of Granite and Sandstone under Uniaxial Compression

Low-Frequency Characteristics of Vibrations Induced by Transient Unloading of In Situ Stress and Its Influence on Safety of a Deeply Buried Tunnel

Study on Mechanical and Acoustic Emission Characteristics of Backfill–Rock Instability under Different Stress Conditions