Abstract:In cities around the world, underground railways offer an environmentally friendly solution to society’s increasing demand for mass transport. However, they are often constructed close to sensitive buildings, where the resulting ground-borne noise and vibration can cause disturbance to both the occupants and the equipment. Such a scenario occurred in central London, where the new twin tunnels of Crossrail were bored beneath the Grand Central Recording Studios, causing an immediate concern. As a result, vibration in the studios’ building was monitored throughout the Crossrail construction period. Since Crossrail is yet to operate, the resulting data provide a unique opportunity to investigate the effect of new tunnels, acting as passive buried structures, on the existing vibration environment. This paper presents the results of such an investigation, together with complementary results from a theoretical four-tunnel boundary-element model. The data analysis, presented in the first half of the paper, indicates that the construction of the second Crossrail tunnel has led to an overall reduction in the noise and vibration levels beneath the studios, due to the operation of the nearby Central line trains of London Underground. This is predominantly due to a reduction of approximately 6 dB in the 63 Hz band-limited levels but accompanied by a slight increase, of approximately 2 dB, in the 125 Hz band. Further analysis indicates that any seasonal variations in vibration levels over the measurement period are negligible, adding weight to the conclusion that the observed changes are a causal effect of the tunnel. The second half of the paper presents results from the model, which aims to simulate the dynamic interaction between the Central line tunnels and those of Crossrail. With nominal parameter values, the results demonstrate qualitative similarities with the measurement findings, thereby adding to the growing body of evidence that dynamic interaction between neighbouring tunnels can be significant.

Validation of the Pipe in Pipe vibration software model to determine ground-borne noise and vibration levels above construction tunnels and the determination of end corrections for different train operating scenarios

Validating pipe-in-pipe vibration software model to accurately determine ground-borne noise and vibration above construction tunnels

Discrete Element Analysis of a Cross-River Tunnel under Random Vibration Levels Induced by Trains Operating During the Flood Season

The dynamic interaction effects of railway tunnels: Crossrail and the Grand Central Recording Studios

Investigating the impact of tunnel geometry on ground-borne noise and vibration from underground railways

Centrifugal model tests on impact of environmental vibration on scientific device-housed tunnel and vibration reduction schemes

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Assessing subway network ground borne noise and vibration using transfer function from tunnel wall to soil surface measured by muck train operation

Investigation of Environmental Vibration Control for High Speed and Heavy Haul Railway

The Wave Function Method for Calculation of Vibrations from a Twin Tunnel in a Multi-Layered Half-Space

New Technique for Ground Vibration Mitigation by Horizontally Buried Hollow Pipes

Prediction of low frequency vibration propagation from operating rail tunnels

Prediction method and experimental verification of vibration response caused by underground high-speed railways

Performance of rubber-concrete composite periodic barriers applied in attenuating ground vibrations induced by metro trains

Modelling, simulation and evaluation of ground vibration caused by rail vehicles

Prediction of Railway-Induced Ground Vibrations in Tunnels

Assessment and mitigation of railway-induced environmental vibrations over underground comprehensive transportation hub

Vibration characteristics of subway turnout area during vehicle deceleration and assessment of the model accuracy

A model for ground vibration from railway tunnels

Centrifuge modelling of ground-borne vibrations induced by railway traffic in underground tunnels

Horizontal Hollow Pipes Used As Vibration Isolation Barriers: Numerical Modelling and Design Optimization