Proppant transport law in multi-branched fractures induced by volume fracturing
GUO Tiankui,LYU Mingkun,CHEN Ming,XU Yun,WENG Dingwei,QU Zhanqing,DAI Caili,HOU Jian,LIU Xiaoqiang,Tiankui GUO,Mingkun LYU,Ming CHEN,Yun XU,Dingwei WENG,Zhanqing QU,Caili DAI,Jian HOU,Xiaoqiang LIU
DOI: https://doi.org/10.1016/s1876-3804(23)60441-0
IF: 5.194
2023-08-20
Petroleum Exploration and Development
Abstract:To further clarify the proppant transport and placement law in multi-branched fractures induced by volume fracturing, proppant transport simulation experiments were performed with different fracture shapes, sand ratios, branched fracture opening time and injection sequence of proppants in varied particle sizes. The results show that the settled proppant height increases and the placement length decreases in main fractures as the fracturing fluid diverts gradually to the branched fractures at different positions. The flow rate in branched fractures is the main factor affecting their filling. The diverion to branched fractures leads to low flow rate and poor filling of far-wellbore branched fractures. The inclined fracture wall exerts a frictional force on the proppant to slow its settlement, thus enhancing the vertical proppant distribution in the fracture. The increase of sand ratio can improve the filling of near-wellbore main fracture and far-wellbore branched fracture and also increase the settled proppant height in main fracture. Due to the limitation of fracture height, when the sand ratio increases to a certain level, the increment of fracture filling decreases. When branched fracture is always open (or extends continuously), the supporting effect on the branched fractures is the best, but the proppant placement length within the main fractures is shorter. The fractures support effect is better when it is first closed and then opened (or extends in late stage) than when it is first opened and then closed (or extends in early stage). Injecting proppants with different particle sizes in a specific sequence can improve the placement lengths of main fracture and branched fracture. Injection of proppants in an ascending order of particle size improves the near-wellbore fracture filling, to a better extent than that in a descending order of particle size.
energy & fuels,geosciences, multidisciplinary,engineering, petroleum