Abstract:Three-dimensional (3D) integration technology using Cu interconnections has emerged as a promising solution to improve the performance of silicon microelectronic devices. However, Cu diffuses into SiO2 and requires a barrier layer such as Ta to ensure acceptable reliability. In this paper, the effects of temperature and strain normal to the interface on the inter-diffusion of Cu and Ta at annealing conditions are investigated using a molecular dynamics (MD) technique with embedded atomic method (EAM) potentials. Under thermal annealing conditions without strain, it is found that a Cu-rich diffusion region approximately 2 nm thick is formed at 1000 K after 10 ns of annealing. Ta is capable of diffusing into the interior of Cu but Cu hardly diffuses into the inner lattice of Ta. At the Cu side near the interface an amorphous structure is formed due to the process of diffusion. The diffusion activation energy of Cu and Ta are found to be 0.9769 and 0.586 eV, respectively. However, when a strain is applied, a large number of crystal defects are generated in the sample. As the strain is increased, extrinsic stacking faults (ESFs) and lots of Shockley partial dislocations appear. The density of the dislocations and the diffusion channels increase, promoting the diffusion of Cu atoms into the inner lattice of Ta. The thickness of the diffusion layer increases to 4 times the value when only a temperature load of 700 K is applied. The MD simulations demonstrated that Ta is very effective as a barrier layer under thermal loading only, and its effectiveness is impaired by tensile strain at the Cu/Ta interface. The simulations also clarified the mechanism that caused the impairment. The methodology and approach described in this paper can be followed further to study the effectiveness of barrier layers under various annealing and strain conditions, and to determine the minimum thickness of barrier layers required for a particular application.

Molecular dynamics simulation of diffusion bonding of Al–Cu interface

Study on interface behavior of Be/CuCrZr alloy by diffusion bonding

The diffusion behaviors at the Cu-Al solid-liquid interface: A molecular dynamics study

Al-clad Cu Bond Wires for Power Electronics Packaging: Microstructure Evolution, Mechanical Performance, and Molecular Dynamics Simulation of Diffusion Behaviors

Atomic diffusion behavior and diffusion mechanism in Fe–Cu bimetal casting process studied by molecular dynamics simulation and experiment

Effect of atomic diffusion on interfacial heat transfer and tensile property of copper/aluminum composites

Molecular dynamics simulation of the direct bonding of (111)-oriented nanotwinned Cu and its related mechanical behavior

Molecular dynamics simulation of atomic diffusion in friction stir spot welded Al to Cu joints

On the Evolution of Nano-Structures at the Al–Cu Interface and the Influence of Annealing Temperature on the Interfacial Strength

Interface Behaviors and Mechanical Properties of Diffusion Bonded 45 Steel/additive Manufactured 316L Steel Joints

Investigation on the Diffusion Behaviors and Mechanical Properties of the Ti/Al Interface Using Molecular Dynamics Simulation

Diffusion behavior of Cu/Ta heterogeneous interface under high temperature and high strain: An atomistic investigation

Impact of crystalline orientation on Cu–Cu solid-state bonding behavior by molecular dynamics simulations

Interdiffusion cross-high-entropy alloys, nano-multilayer foils, and Al interface: An atomistic simulation

Study on inhibition of interfacial compounds and improvement of joint properties by low temperature and high-pressure process in diffusion bonding of Ti/Cu

Molecular dynamics simulation of diffusion in supercooled Cu–Zr alloys

Interface Development in Cu-Based Structures Transient Liquid Phase (TLP) Bonded with Thin Al Foil Intermediate Layers

Interdiffusion of Ni-Al multilayers: a continuum and molecular dynamics study

Molecular Dynamics Simulation of the Coalescence and Melting Process of Cu and Ag Nanoparticles

Interdiffusion In Liquid Al-Cu And Ni-Cu Alloys

Study on diffusion characteristics of Al-Cu systems and mechanical properties of intermetallics