Abstract:In this work a hardware-in-the-loop (HiL) simulator of a novel micro combined heat and power system is presented and its use for control algorithm optimization is demonstrated and discussed. The plant under investigation consists of a concentrated Linear Fresnel Reflectors solar field, a 2 kWe/18 kWt Organic Rankine Cycle unit and an advanced latent heat thermal energy storage tank equipped with reversible heat pipes as developed by a consortium of universities and companies within the EU funded project Innova Microsolar. A smart control unit manages their integration and monitors the operation of each subsystem. In order to support the optimization of the control algorithms and the definition of the best control strategy of the micro-CHP plant at different working conditions, a simulation framework based on Matlab/Simulink has been developed by the authors and connected to the real control unit according to a HiL approach. Ad-hoc models of the different subsystems together with those of the components (i.e. valves and variable speed pumps) regulating the plant operation have been included. The use of the HiL simulator has permitted to optimize the control logic of the integrated plant prior to its future commissioning, thus helping to overcome some of the technical and reliability issues occurring during the setup of the real system. In particular, the HiL has allowed: (i) to define the proportional and integral gains of the diverters in order to assure a robust and fast response of the plant during the switch among the different operation modes; (ii) to prove the limits of acting on the oil pump flow rate in assuring the nominal oil temperature at the inlet of the ORC unit, due to the inherent fluctuations caused by this control strategy; and (iii) to assess the best control strategy which is obtained by acting on the aperture of the diverter which controls the oil mass flow rate to the ORC unit. Hence, the scientific approach here proposed can be extended also to many other complex energy conversion systems in order to significantly reduce the potential critical issues during their commissioning.

Implementation of an FPGA-Based Online Hardware-in-the-Loop Emulator Using High-Level Synthesis Tools for Resonant Power Converters Applied to Induction Heating Appliances

Development of a hardware-in-the-loop simulator for small-scale concentrated solar combined heat and power system

Real-Time Thermal Evaluation of Power Converters in Microgrids by Device Current Reconstruction

Device‐level Modelling and FPGA‐based Real‐time Simulation of the Power Electronic System in Fuel Cell Electric Vehicle

Hardware Emulation of Step-Down Converter Power Stages for Digital Control Design

Implementation of an FPGA-based Real-Time Emulator for the Rapid Validation of Power Electronics System in Fuel Cell Electric Vehicle

Dc-Link Ripple Suppression of Cascaded H-Bridge Based MV Grid Emulator Apparatus for Analysis and Testing of Grid-Tied Converters in Distribution System

A Novel Converter-Based PV Emulator Control Using Lambert W Method and Fractional-Order Fuzzy Proportional-Integral Controller Trained by Harris Hawks Optimization

Evaluation of Operating Range of a Machine Emulator for a Back-to-Back Power-Hardware-in-the-Loop Test Bench

An Artificial Neural Network-Based System-Level Modeling of Power Converters for Real-Time Simulation

FPGA-Based Real-Time Simulation of High-Power Electronic System with Nonlinear IGBT Characteristics

Real-time Implementation of a Dual-Active-Bridge Based Multi-Level Photovoltaic Converter

A Network Analysis Modeling Method of the Power Electronic Converter for Hardware-in-the-Loop Application

High-Performance Implementation of Power Components on FPGA Platform

Real-Time Simulation of Power Electronic Systems Based on Predictive Behavior

A High-Performance and Cost-Effective Field Programmable Gate Array-Based Motor Drive Emulator

FPGA Implementation for Rapid Prototyping of High Performance Voltage Source Inverters

A Semi-Implicit Parallel Leapfrog Solver with Half-Step Sampling Technique for FPGA-Based Real-Time HIL Simulation of Power Converters

FPGA Implementation of a PV Generator and a Boost Converter Controllers for a Virtual Laboratory Environment

Design and Implementation of a Photovoltaic Emulator Using an Insulated Full Bridge Converter Based Switch Mode Power Supply

Control Strategy of a High Power Grid Simulator for the Test of Renewable Energy Grid Converter.