Optimization and Modeling of Cr (VI) Removal from Tannery Wastewater onto Activated Carbon Prepared from Coffee Husk and Sulfuric Acid (H2SO4) as Activating Agent by Using Central Composite Design (CCD)
Amibo Temesgen Abeto,Bayan Surafel Mustafa,Bayu Abreham Bekele,Kabeta Worku Firomsa
DOI: https://doi.org/10.1155/2023/5663261
2023-01-31
Journal of Environmental and Public Health
Abstract:The primary goal of this research is to lower the hexavalent chromium (Cr (VI)) concentration that has occurred from the growth of the tannery industry. As a result, the potential for heavy metal concentration is increasing day by day. Industrial effluent containing Cr (VI) contributes significantly to water pollution. Chromium hexavalent ion (Cr (VI)) in wastewater is extremely hazardous to the environment. It is critical to address such a condition using activated carbon derived from biomass. Adsorption is one of the most successful methods for removing hexavalent chromium from wastewater. Treated wastewater has no substantial environmental contamination consequences. The ash content, moisture content, volatile matter content, and fixed carbon content of wet coffee husk were 3.51, 10.85, 68.33, and 17.31, respectively. The physicochemical properties of coffee husk-based activated carbon (CHBAC) obtained during experimentation were pH, porosity, the yield of CHBAC, bulk density, point of zero charges, and specific surface area of 5.2, 58.4 percent, 60.1 percent, 0.71 g/mL, 4.19, and 1396 m2/g, respectively, indicating that CHBAC has a higher capacity as an adsorbent medium. For optimization purposes, the parameters ranged from pH (0.3–3.7), dose (2.3–5.7) g , and contact time (0.3–3.7) hr. The quadratic models were chosen for optimization, and the p value for the model was significant since it was less than 0.05, but the lack of fit model was inconsequential because it was more than 0.05. The optimum adsorption obtained with numerical optimization of Cr (VI) was 97.65 percent. This was obtained at a pH of 1.926, a dose of 4.209 g/L, and a contact time of 2.101 hours. This result was observed at a pH of 1.93, a dosage of 4.2 g/L, and a contact duration of 2.1 hours. The desirability obtained during numerical optimization was 1. Coffee husk-based activated carbon has a bigger surface area, and it has a stronger ability to absorb hexavalent chromium from tannery wastewater effluents.