Abstract:Understanding the aerodynamic performance of scaled-down models is vital for providing crucial insights into wind energy optimization. In this study, the aerodynamic performance of a scaled-down model (12%) was investigated. This validates the findings of the unsteady aerodynamic experiment (UAE) test sequence H. UAE tests provide information on the configuration and conditions of wind tunnel testing to measure the pressure coefficient distribution on the blade surface and the aerodynamic performance of the wind turbine. The computational simulations used shear stress transport and kinetic energy (SST K-Omega) and transitional shear stress transport (SST) turbulence models, with wind speeds ranging from 5 m/s to 25 m/s for the National Renewable Energy Laboratory (NREL) Phase VI and 4 m/s to 14 m/s for the 12% scaled-down model. The aerodynamic performance of both cases was assessed at representative wind speeds of 7 m/s for low, 10 m/s for medium, and 20 m/s for high flow speeds for NREL Phase VI and 7 m/s for low, 9 m/s medium, and 12 m/s for the scaled-down model. The results of the SST K-Omega and transitional SST models were aligned with experimental test measurement data at low wind speeds. However, the SST K-Omega torque values exhibited a slight deviation. The transitional SST and SST K-Omega models yielded aerodynamic properties that were comparable to those of the 12% scaled-down model. The torque values obtained from the simulation for the full-scale NREL Phase VI and the scaled-down model were 1686.5 Nm and 0.8349 Nm, respectively. Both turbulence models reliably predicted torque and pressure coefficient values that were consistent with the experimental data, considering specific flow regimes. The pressure coefficient was maximum at the leading edge of the wind turbine blade on the windward side and minimum on the leeward side. For the 12% scaled-down model, the flow simulation results bordering the low-pressure region of the blade varied slightly.

Comparisons of Predicted and Measured Aerodynamic Characteristics of the DLR LK6E2 Missile Airframe (Scale Resolving)

Numerical Investigation of Unsteady Aerodynamic Characteristics of A Pitching Missile

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

Experimental and Numerical Determination of the Aerodynamic Characteristics of a Cruise Missile Model

Prediction of Separation Induced Transition on Thick Airfoil Using Nonlinear URANS Based Turbulence Model

Numerical study on aerodynamic characteristics of rotating missile launched vertically under strong transverse wind

The influence of roll angles on unsteady aerodynamics in a canard‐configured missile

Aerodynamic Characterization of a Generic High-Speed Projectile Configuration

Numerical Investigation of Model Support, Closed Engine Nacelle and Scale Effect on a Wind Tunnel Test Model

Aerodynamic Characterization of a Hypersonic Projectile Using Acceleration-Based Measurements and Numerical Methods

Dynamics Characterization of Missiles with Control Flaps Based on CFD

Analysis of Turbulent Separated Flows for the NREL Airfoil Using Anisotropic Two-Equation Models at Higher Angles of Attack

Numerical study of induced nonlinear rolling moment of finned missile at high angles of attack

The effects of turbulence modeling on dynamic stall

Numerical Simulation of a Wind Turbine Airfoil: Dynamic Stall and Comparison with Experiments

Laminar Transition over Airfoil: Numerical Simulation of Turbulence Models and Experiment Validation

Sensitivities of Free-Air RANS and DDES Methods on the High-Lift NASA CRM

Studying the influence of the turbulence model on the aerodynamic characteristics of a cruise missile model

Effect of span size in Scale Resolving Simulations of airfoil stall and post-stall

Aerodynamic Performance and Numerical Validation Study of a Scaled-Down and Full-Scale Wind Turbine Models

Numerical Investigation of the Aerodynamic Characteristics of a Missile