Abstract:Ultrasonic damage detection and characterization is commonly used in nondestructive evaluation (NDE) of aerospace composite components. However, in real materials and structures, the dispersive waves can result in complicated behavior, particularly in the presence of complex damage scenarios and structural components. Accurate three dimensional finite element models (FEMs), using PZFlex, of guided wave interactions with realistic damage scenarios can be used to study quantitative NDE ultrasonic damage detection techniques numerically, to supplement or replace expensive experimental testing. Novel data analysis techniques such as filter reconstruction imaging methods can be used to create practical comparisons between experimental and simulated data. To compare experimental and simulated data, however, the FEM must accurately simulate the physics of an ultrasonic inspection. This requires that information about the damage be known a priori (e.g. through CT scans of the laminates). While possible in a research setting, this is typically not the case for real inspections in which the goal is to characterize the unknown damage. This work will describe a means of parameterizing a FEM of a composite laminate for use in a damage characterization scheme. The FEM is parameterized with a multidimensional damage model capable of describing the complex amage typical of low impact strikes in composites. The damage under consideration in this work is described by the spiraling, multilayer delamination depicted in Figure 1. Experimental laser Doppler vibrometer (LDV) wavefield data and the FEM simulated vibration responses are postprocessed using the 3D Fourier transform so that the wavenumber-frequency spectra can be readily compared, building on the results and methods in [1]. The purpose of the parameterized damage model is for use in a probabilistic damage characterization methodology, discussed in a companion presentation [2]. The composite laminate model and the ultrasonic inspection are simulated using PZFlex and allows for iterative refinement of the damage. The increasing model fidelity enables fast localization of the damage followed by subsequent refined characterization.

Guided wave energy trapping to detect hidden multilayer delamination damage

Ultrasonic Full Guided Wavefield for Damage Detection in Curved CFRP Parts

Guided waves in anisotropic and quasi-isotropic aerospace composites: three-dimensional simulation and experiment

Guided Ultrasonic Wave Monitoring of Damage in Anisotropic Composites

Delamination Detection in Composite Plates Using Linear and Nonlinear Ultrasonic Guided Waves

Guided Ultrasonic Wave-Based Technique for Assessment of Composite Structures with Prior Damage

A Parameterized Delamination Model for Use in Complex Damage Characterization of Composite Laminatesin Ultrasonic Inspections

Numerical Simulation on Micro-damage Detection In CFRP Composites Based on Nonlinear Ultrasonic Guided Waves

Scattering of guided waves at delaminations in composite plates

Non-contact Detection of Delamination in Layered Anisotropic Composite Materials with Ultrasonic Waves Generated and Detected by Lasers

Damage Detection For Laminated Composite Structures With Wavelet Analysis

Guided wavefield curvature imaging of invisible damage in composite structures

Damage Detection in Composite Structures Via Scanning Laser Doppler Vibrometry Using Linear and Nonlinear Ultrasonic Wave Features

Numerical Investigation of Nonlinear Interactions Between Multimodal Guided Waves and Delamination in Composite Structures

Detection of Multi-Layered Bond Delamination Defects Based on Full Waveform Inversion

Visualization of hidden delamination and debonding in composites through noncontact laser ultrasonic scanning

Ultrasonic detection and characterization of delamination and rich resin in thick composites with waviness

Modeling of ultrasonic wave propagation in composite laminates with realistic discontinuity representation

Wavelet-aided guided wavefield imaging of delaminations in laminated composite plates

Numerical Simulation of Carbon Fiber Reinforced Polymer Composite Delamination Damage Identification Using Lamb Wave and Filtered Back-Projection Method

Multi-frequency localized wave energy for delamination identification using laser ultrasonic guided wave