Fluid Behaviour Analysis on Liquefaction Using Korinofaction Device

A Sentani,Soedarsono,E K Soeridjal
DOI: https://doi.org/10.1088/1755-1315/955/1/012013
2022-01-01
IOP Conference Series: Earth and Environmental Science
Abstract:Abstract Earthquakes can be followed by liquefaction, which is a response of saturated soil when it is subjected to shock or stress that cause loss of soil strength or bearing capacity as an impact of the increasing of soil pore water and the loss of the soil stress’s effectiveness. This research using Korinofaction that work to cause cyclic loads or vibrations that come from DC servo motor with an adjustable speed and force. The earthquake’s strength is measured by the number of rpm measured on the digital tachometer. Korinofaction is equipped with plumbing system to observe fluid behaviour during liquefaction. The results of research showed that silty sand and silt was liquefied in VIII Modified Mercalli Intensity earthquake and cause the occurrence of water flow on the surface due to increase soil pore stress. The flow rate that triggers liquefaction in the silty sand is 6,769 × 10-5 m 3 / second ’ and silt is 5,0 × 10-5 m 3 / second . The water flow that flows in the silty sand had permeability of 4,76 × 10-4 Cm / second while on the silt is 6,09 × 10-4 Cm / second . After liquefaction, gradient hydraulic of silty sand is 4,76 mm and silt is 6,09 mm. Based on this research liquefaction caused mobilized debris flow and muddy debris flow.
What problem does this paper attempt to address?