Abstract:An elasto-plastic contact modeling approach is proposed to characterize the total contact load and real contact area of rough surface.The finite element method (FEM) is firstly used to analyze the elasto-plastic contact behaviors of asperity against the rigid flat.The effects of four different plastic yielding equations on the load and real area of asperity contact are analyzed.The relations between the dimensionless contact load and the dimensionless deformation calculated with four different plastic yielding equations are the same,and the solutions vary between the Hertz solution and the AF model.Based on the contact stress distributions of different contact loads,the asperity contact regime is divided into the elastic regime,the mixed elasto-plastic regime and the fully plastic regime.The increasing change of contact stress distribution is considered when obtaining the relation between the contact load and the contact deformation.Statistical analysis of the GW (Greenwood J A and Williamson J B P) model is then applied to integrate the formulations of contact load over the rough surface.The model is compared with the purely elastic model,the CEB model,the ZMC model,the KE model and the JG model,and the effect of plasticity index on the relation between the contact load and the mean contact separation of rough surface is also investigated.The results show that the proposed model can better describe the relation between contact load and deformation.The total contact load of rough surface predicted by the proposed method agrees well with the KE model and the ZMC model.With the increase of mean contact separation,the total contact load becomes smaller.The plasticity index has a great effect on the contact load predicted by different models.The difference between the total contact load of rough surface calculated by 6 elasto-plastic models is small at a lower plasticity index,while the difference is greater at a higher plasticity index,especially for the CEB model;and the CEB model predicts the largest contact load of rough surface.

Plane Contact and Partial Slip Behaviors of Elastic Layers With Randomly Rough Surfaces

Studies of Low-loading Micro-slip Contacts on Rough Surfaces with GW Model

Adhesive Contact of A Power-Law Graded Elastic Half-Space with A Randomly Rough Rigid Surface

Modeling Tangential Contact of Rough Surfaces with Elastic-And Plastic-Deformed Asperities

A Self-Consistent Model for the Elastic Contact of Rough Surfaces

A Fully Coupled Normal and Tangential Contact Model to Investigate the Effect of Surface Roughness on the Partial Slip of Dissimilar Elastic Materials

Partial Slip Contact Analysis on Three-Dimensional Elastic Layered Half Space

Normal Contact Model for Elastic and Plastic Mechanics of Rough Surfaces

An Improved Elastic–plastic Contact Model with Asperity Interactions Based on Greenwood–Williamson Theory

Research of Contact Pressure of an Elastoplastic Rough Body in Contact with A Smooth Rigid Plane

A Simplified Numerical Elastic-Plastic Contact Model for Rough Surfaces

Modeling for Normal Contact of Rough Surface Based on Stress Distribution of Asperity Contact

Modeling and Simulation of Dynamical Contact of Asperities Between Flat Rough Surfaces

Thermomechanical modeling and transient analysis of sliding contacts between an elastic–plastic asperity and a rigid isothermal flat

Adhesive Contact on Randomly Rough Surfaces Based on the Double-Hertz Model

NUMERICAL ANALYSIS OF ASPERITY CONTACT MODEL BASED ON MOLECULAR DYNAMICS-GREEN'S FUNCTION METHOD

A Study of Elastic–plastic Contact of Statistical Rough Surfaces

A new analytical model for the contact of Gaussian rough surfaces

Modeling Tangential Contact Based on Non-Gaussian Rough Surfaces

A Numerical Model for the Elastic Contact of Three-Dimensional Real Rough Surfaces

Modeling for Microslip Behavior of Lap Joints Based on Non-Gaussian Rough Surfaces