Abstract:Permanent magnets (PM) are critical components for electric motors and power generators. Key properties of permanent magnets, especially coercivity and remanent magnetization, are strongly dependent on microstructure. Understanding metallurgical processing, phase stability and microstructural changes are essential for designing and improving permanent magnets. The widely used PM for the traction motor in electric vehicles and for the power generator in wind turbines contain rare earth elements Nd and Dy due to their high maximum energy product. Dy is used to sustain NdFeB's coercivity at higher temperature. Due to the high supply risk of rare earth elements (REE) such as Dy and Nd, these elements are listed as critical materials by the U.S. Department of Energy and other international institutes. Other than Dy, finer grain size is also found to have effect on sustaining coercivity at higher temperature. A proper control of phase stability and microstructures has direct impact on mitigating REE supply risk. Compared to rare earth PMs, non-rare earth (non-RE) PMs typically have lower maximum energy products, however, given their small supply risks and low cost, they are being intensively investigated for less-demanding applications. The general goal for the development of non-RE PMs is to fill in the gap between the most cost-effective but low performing hard ferrite magnet and the most expensive but high performing RE PMs. In the past five years great progress has been made toward improving the microstructure and physical properties of non-RE PMs. Several new candidate materials systems were investigated, and some have showed realistic potential for replacing RE PMs for some applications. In this article, we review the science and technology of various types of non-RE materials for PM applications. These materials systems include Mn based, high magnetocrystalline anisotropy alloys (MnBi and MnAl compounds), spinodally decomposing alloys (Alnico), high-coercivity tetrataenite L10 phase (FeNi and FeCo), and nitride/carbide systems (such as α" based, high saturation magnetization Fe16N2 type phase and Co2C/Co3C acicular particle phase). The current status, challenges, potentials as well as the future directions for these candidates non-RE magnet materials are discussed.

Strong magnets with ordered structures

Structure Engineering of 2D Materials toward Magnetism Modulation

High-throughput search for potential permanent magnet materials

Micromagnetics of rare-earth efficient permanent magnets

First-principles study of permanent magnets

Magnetoelectric Tuning of Pinning‐Type Permanent Magnets through Atomic‐Scale Engineering of Grain Boundaries

Perspectives on Permanent Magnetic Materials for Energy Conversion and Power Generation

Hot-deformed Nd-Fe-B Magnet with Macroscopic Composite Structure

Current Progress and Future Challenges in Rare-Earth-free Permanent Magnets

Strong and ductile high temperature soft magnets through Widmanstätten precipitates

Superstrength permanent magnets with iron-based superconductors by data- and researcher-driven process design

Enhancing Magnetic Ordering in Two-Dimensional Metal-Organic Frameworks via Frontier Molecular Orbital Engineering

Computational Design of the Rare-Earth Reduced Permanent Magnets

Tailoring magnetism in artificially structured materials: the new frontier

Metal-organic magnets with large coercivity and ordering temperatures up to 242°C

Chemical Synthesis of Next Generation High Energy Product Hybrid SmCo Permanent Magnets for High Temperature Applications

Prospect and status of iron-based rare-earth-free permanent magnetic materials

Recent progress on emergent two-dimensional magnets and heterostructures

Intrinsically High Magnetic Performance in Core–Shell Structural (Sm,Y)Fe12‐Based Permanent Magnets (Adv. Mater. 28/2022)

Advance in the Chemical Synthesis and Magnetic Properties of Nanostructured Rare-Earth-based Permanent Magnets

Permanent Magnets Beyond Nd-Dy-Fe-B