Abstract:The biosorption of heavy metals especially, Cd 2+ , Pb 2+ , and Zn 2+ from wastewater were evaluated using the biomass of macroalgae, Hypnea valentiae found in coastal waters of Rameshwaram, Tamil Nadu, India. The probable functional groups involved in the biosorption process was analyzed by Fourier transform infrared spectroscopy. The specific surface area, pore volume and pore diameter of prepared biosorbent was determined by Brunauer–Emmett–Teller (BET) analysis and it was found to be 59.993 m 2 g −1 , 0.292 cc g −1 and 1.429 nm, respectively. The scanning electron microscopy images after the biosorption revealed that the heavy metals have been adsorbed on to the surface of biosorbent. The optimization study was performed using Box–Behnken design and the optimum parameters used were initial concentration of metal ions (10–500 mg L −1 ), biomass dose (5–25 g L −1 ), contact time (10–120 min), temperature (25–45 °C), agitation speed (60–120 rpm) and pH (2–14). The heavy metal uptake (biosorption) was assessed by isotherm models including Dubinin–Radushkevich (D–R), Freundlich and Langmuir models. The maximum sorption of metal ions was observed in Langmuir isotherm model ( R L 0.1773 and K F 2.2030 L mg −1 ) with an R 2 value close to 0.99 clearly indicating the chemical mode of metal ion adsorption. Also, the sorption of Cd 2+ , Pb 2+ , and Zn 2+ on to the surface of algal biomass followed pseudo-second-order kinetics with a rate constant, k 2 being 9.627 × 10 −3 g (mg min) −1 and q e being 93.98496 mg g −1 , strongly supporting the chemisorption mechanism. The computed thermodynamic parameters (ΔG°, ΔH, and ΔS) demonstrated an endothermic, spontaneous biosorption that was feasible. The maximum removal efficiency was achieved for Pb (92.86%) followed by Cd (91.48%) and Zn (87.32%). The biosorbent can be reused and regenerated up to four cycles efficiently. There was a significant reduction in the biological oxygen demand, chemical oxygen demand, total dissolved solids, and pH of wastewater after treatment with the biosorbent. From this study, it is assessed that the biomass from red algae can be utilized for the biosorption of heavy metals from polluted water which is cost-effective and eco-friendly.

Hydrothermal Carbonization of Residual Algal Biomass for Production of Hydrochar as a Biobased Metal Adsorbent

Synthesis of Al-Modified Hydrochar from Corn Stover for Efficient Phosphate Removal

Hydrothermal conversion of the hyperaccumulator Sedum alfredii Hance for efficiently recovering heavy metals and bio-oil

Graphitic bio-char and bio-oil synthesis via hydrothermal carbonization-co-liquefaction of microalgae biomass (oiled/de-oiled) and multiple heavy metals remediations

Microalgae realizes self N-doped biochar for heavy metal polluted sediment remediation

Influence of hydrothermal carbonization conditions on the porosity, functionality, and sorption properties of microalgae hydrochars

Conversion of seaweed waste to biochar for the removal of heavy metal ions from aqueous solution: A sustainable method to address eutrophication problem in water bodies

Enhancing the removal of sulfamethoxazole and microalgal lipid production through microalgae-biochar hybrids

Research advances on production and application of algal biochar in environmental remediation

Production of hydrochar from the hydrothermal carbonisation of food waste feedstock for use as an adsorbent in removal of heavy metals from water

Pyrolysis of marine algae for biochar production for adsorption of Ciprofloxacin from aqueous solutions

Sustainable Conversion of Harmful Algae Biomass into a CO2 Reduction Electrocatalyst for Two-Fold Carbon Utilization

Hydrochar as a bio-based adsorbent for heavy metals removal: A review of production processes, adsorption mechanisms, kinetic models, regeneration and reusability

Incorporating hydrothermal liquefaction into wastewater treatment – Part II: Characterization, environmental impacts, and potential applications of hydrochar

Co-pyrolysis Route of Chlorella Sp. and Bauxite Tailings to Fabricate Metal-Biochar As Persulfate Activator

Effective removal of microplastics by filamentous algae and its magnetic biochar: Performance and mechanism

Carbon dioxide-assisted thermochemical conversion of magnetically harvested harmful algae into syngas and metal biochar

Enhanced microalgal biomass and lipid production with simultaneous effective removal of Cd using algae-bacteria-activated carbon consortium added with organic carbon source

Heavy metals removal by algae and usage of activated metal-enriched biomass as cathode catalyst for improving performance of photosynthetic microbial fuel cell

Remediation of Heavy Metals in Polluted Water by Immobilized Algae: Current Applications and Future Perspectives

Efficient and sustainable approach of heavy metal adsorption from wastewater using algal biomass of Hypnea valentiae (Turner) Montagne, 1841