Abstract:Objective . Noninvasive measurement of oxygen saturation (SpO 2 ) using pulse oximetry based on transmissive photoplethysmography (tPPG) is clinically accepted and widely employed. However, reflective photoplethysmography (rPPG) - present in smartwatches - has not become equally accepted, partially because the pathlengths of the red and infrared PPGs are patient-dependent. Thus, even the most popular "Ratio of Modulation" (R) method requires patient-dependent calibration to reduce the errors in the measurement of SpO2 using rPPGs. Approach . In this paper, a correction factor or "pathlength ratio" β is introduced in an existing calibration-free algorithm that compensates the patient-dependent pathlength variations, and improved accuracy is obtained in the measurement of SpO2 using rPPGs. The proposed β is derived through the analytical model of a rPPG signal. Using the new expression and data obtained from a human hypoxia study wherein arterial oxygen saturation values acquired through Blood Gas Analysis were employed as a reference, β is determined. Main results . The results of the analysis show that a specific combination of the β and the measurements on the pulsating part of the natural logarithm of the red and infrared PPG signals yields a reduced root-mean-square error (RMSE). It is shown that the average RMSE in measuring SpO2 values reduces to 1 %. Significance . The human hypoxia study data used for this work, obtained in a previous study, covers SpO 2 values in the range from 70 % to 100 %, and thus shows that the pathlength ratio β proposed here works well in the range of clinical interest. This work demonstrates that the calibration-free method applicable for transmission type PPGs can be extended to determine SpO 2 using reflective PPGs with the incorporation of the correction factor β. Our algorithm significantly reduces the number of parameters needed for the estimation, while keeping the RMSE below the clinically accepted 2 %.

Quantifying Blood-Oxygen Saturation Measurement Error in Motion Contaminated Pulse Oximetry Signals

Model Design and System Implementation for the Study of Anti-motion Artifacts Detection in Pulse Wave Monitoring

SpO2 Measurement Algorithm for PPG Signal with Motion Artifacts

Reduction of Motion Artifact in Pulse Oximetry by Smoothed Pseudo Wigner-Ville Distribution

Electronic health record data is unable to effectively characterize measurement error from pulse oximetry: a simulation study

Robust Modelling of Reflectance Pulse Oximetry for SpO$_2$ Estimation

Wrist02 -- Reliable Peripheral Oxygen Saturation Readings from Wrist-Worn Pulse Oximeters

[Research on dynamic blood oxygen saturation measurement based on motion noise reconstruction combined with convex combination least mean square adaptive filter]

Robust Modelling of Reflectance Pulse Oximetry for SpO2 Estimation

Accuracy enhancement in reflective pulse oximetry by considering wavelength-dependent pathlengths

An Efficient Motion-Resistant Method for Wearable Pulse Oximeter.

Removal of Motion Artifacts in PPG Signals Based on the CEEMDAN-MPE and VS_LMS Adaptive Filter

Accuracy Analysis of Pulse Oximetry Based on Dynamic Spectroscopy

Evaluating the Impact of Pulse Oximetry Bias in Machine Learning under Counterfactual Thinking

Analysis of Influencing Factors on Pulse Oxygen Saturation Monitoring

Pitfalls and common errors of anaesthetic monitoring devices. Part 1: Pulse oximetry

A preliminary study on photoplethysmogram (PPG) signal analysis for reduction of motion artifact in frequency domain

Ratiometric Artifact Reduction in Low Power Reflective Photoplethysmography

Quantifying pulse oximeter accuracy during hypoxemia and severe anemia using an in vitro circulation system

Use of complex EMD generated noise reference for adaptive reduction of motion artifacts from PPG signals

Investigating sources of inaccuracy in wearable optical heart rate sensors