Abstract:In this study, overloaded elution profiles under ultra-high-pressure liquid chromatographic (UHPLC) conditions and accounting for the severe pressure and temperature gradients generated, are compared with experimental data. The model system consisted of an C18 column packed with 1.7-μm particles (i.e., a UHPLC column) and the solute was 1,3,5-tri-tert-butylbenzene eluted with a mobile phase composed of 15/85 (v/v) acetonitrile/water. Two thermal modes were considered, and the solute was eluted at the very high inlet pressures necessary to achieve a highly efficient and rapid chromatographic process, as provided by using columns packed with small particles. However, the high inlet pressure and high linear velocity of the mobile phase caused the production of a significant amount of heat, and consequently, the formation of axial and radial temperature gradients. Due to these gradients, the retention and the mobile phase velocity were no longer constant. Thus, simple mathematical models consisting only of the mass balance equations are unsuitable to properly model the elution profiles. Here, the elution concentration profiles were predicted using a combined two-dimensional heat and mass transfer model, also including the calculation of the mobile phase velocity distribution. The isotherm adsorption model was the bi-Langmuir isotherm model with Henry constants that depended on the local temperature and pressure in the column. These adjustments allowed us to precisely account for changes in the shape and retention of the overloaded concentration profiles in the mobile phase. The proposed model provided accurate predictions of the overloaded concentration profiles, demonstrating good agreement with experimental profiles eluted under severe pressure and temperature gradients in the column even in the most extreme cases where the pressure drops reached 846 bar and the temperature gradients equaled 0.15 K mm −1 and 0.95 K mm −1 in the axial and the radial directions, respectively. In such cases 36% decrease of the retention factor was observed along the column and 2% increase in radial direction. These changes, combined with the velocity distribution, shifted the overloaded elution profile's shock towards the center of the column, advancing approximately 3 mm from its initial position close to the column wall. Ultimately, this resulted in the broadening of the elution band.

Choice of Model for Estimation of Adsorption Isotherm Parameters in Gradient Elution Preparative Liquid Chromatography

Parameter-by-parameter Estimation Method for Adsorption Isotherm in Hydrophobic Interaction Chromatography

Parameter-by-parameter Method for Steric Mass Action Model of Ion Exchange Chromatography: Theoretical Considerations and Experimental Verification.

Stochastic modeling of non-linear adsorption with Gaussian kernel density estimators

Simulation of Levulinic Acid Adsorption in Packed Beds Using Parallel Pore/Surface Diffusion Model

A Statistical Approach to Estimating Adsorption-Isotherm Parameters in Gradient-Elution Preparative Liquid Chromatography

Estimating the parameters of competitive Langmuir adsorption isotherms from measured responses to rectangular pulse injections exploiting equilibrium theory

A regularizing Kohn–Vogelius formulation for the model-free adsorption isotherm estimation problem in chromatography

A Systematic Approach for Estimating Colloidal Particle Adsorption Model Parameters

A Regularization Method for the Reconstruction of Adsorption Isotherms in Liquid Chromatography

An Adjoint Method in Inverse Problems of Chromatography

Comparing Two Models of Gradient Elution in Counter-Current Chromatography

Numerical approximation of a two-dimensional model of non-isothermal reactive liquid chromatography involving slow rates of adsorption–desorption kinetics

Simultaneous Determination of Two-Component Isotherm Parameters and Lumped Mass Transfer Coefficients in RPLC with the 0-1 Model-Inverse Method.

Kinetic and equilibrium adsorption parameters estimation based on a heterogeneous intraparticle diffusion model

Using the reactive/transport dispersive models to simulate a monolithic anion exchanger: Experimental parameter determination, simultaneous model evaluation, and validation

Prediction of overloaded concentration profiles under ultra-high-pressure liquid chromatographic conditions

A versatile noninvasive method for adsorber quantification in batch and column chromatography based on the ionic capacity

Parameter Estimation for Reactive Chromatography Model by Bayesian Inference and Parallel Sequential Monte Carlo

Real-time monitoring of gradient chromatography using dual Kalman-filters

Comparison of Various Methods and Detectors to Determine Isotherms Using Self‐Packed Columns