Abstract:A new method for calculating rolling resistance is developed. This method includes a simplified structural model of a wheel in the form of a rigid cylinder with a thin viscoelastic rim. The wheel loading mode is considered in the absence of shearing (horizontal) force. In the entire contact area, it is assumed that the wheel is gripped with a non-deformable support surface. Deformation of the viscoelastic layer is analyzed on the basis of the Winkle model. In contrast to the previously known ones, the proposed method implies a description of the symmetry breaking in the distribution of contact pressure when a small torque is applied to the wheel, not exceeding the rolling resistance at rest. Contact pressure diagrams are obtained at different values of the torque applied to the wheel. It is shown that as the torque increases, the maximum value of the contact pressure increases, and the position of this maximum shifts in the direction of possible rolling. From the condition of violating the contact area dimensions at the beginning of rolling, an analytical expression is derived for the moment of rolling resistance at rest. The calculated dependence of this moment on the wheel draft is compared with known experimental data. When describing stationary free rolling, the asymmetry of the contact pressure corresponding to the beginning of rolling and the loss of energy during deformation of the viscoelastic material of the wheel rim are taken into account. The dependences of the coefficient of rolling resistance and wheel draft on the speed of the wheel center of mass at a fixed value of the vertical load are obtained. It is shown that taking into account the initial asymmetry of the contact pressure leads to a more intensive increase in the calculated estimates of the resistance coefficient and a less marked decrease in the wheel draft with an increase in rolling speed.

Investigation into the effect of common factors on rolling resistance of belt conveyor

Investigation on Influence of Speed on Rolling Resistance of Belt Conveyor Based on Viscoelastic Properties

Investigation on indentation rolling resistance of belt conveyor based on Hertz contact theory compared with one-dimensional Winkler foundation

A study of indentation rolling resistance to motion of conveyor belts using a generalized Maxwell model of the backing material

Simulation and Experimental Study on Indentation Rolling Resistance of a Belt Conveyor

Temperature characteristics of indentation rolling resistance of belt conveyor

Design Research on Roller of New Fiber Carding Machine

Viscoelastic Indentation and Resistance to Motion of Conveyor Belts Using a Generalized Maxwell Model of the Backing Material

Laboratory measurement of the indentation rolling resistance of conveyor belts

Modeling,simulation and experimental research on a contactless air film conveyor using viscous traction

Investigation of The Dynamic Deflection of Conveyor Belts Via Simulation Modelling Methods on Idler Factor

Research on Air Cushion Flow Field and Bearing Characteristics of Single Row Hole Air Cushion Belt Conveyor

Prediction of Restriction Width of Carcass by Belts for Radial Tires:Theory,Experiment and Simulation

Analysis of the Influence of the Type of Belt on the Energy Consumption of Transport Processes in a Belt Conveyor

Quantitative Analysis on Creeping Deformation of Conveying Belt

Non-Linear Analysis Of Elastic Quality For Belt Drives

Finite Element Analysis for the Effect of Belt Structure on the Rolling Resistance of 11R22.5 Tire

A novel evaluation on rolling resistance characteristics of truck tire through the simplified experimental modal analysis

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

Influence of viscoelastic mechanical properties of rail pads on wheel and corrugated rail rolling contact at high speeds

CALCULATION OF THE COEFFICIENT OF FREE ROLLING RESISTANCE FOR THE WHEEL WITH DEFORMABLE RIM