Abstract:A solar tracker significantly increases the amount of energy harvested by a floating photovoltaic system by adjusting the pose of its photovoltaic (PV) panels to optimize their exposure to the solar rays. Conventional solar trackers perform such an adjustment using actuators, which is energy-consuming and involves complex structures. In this paper, a novel dual-axis wave-driven solar tracker is proposed where the photovoltaic (PV) panel is adjusted by the inertia force and gravity. Actuators are replaced by brakes to fix the pose of the PV panel. The kinematics and dynamics of the system are investigated, which are further used for the state feedback and the formulation of the control strategy. A sliding-mode observer is used to estimate the effect of winds on the system, which enables the robustness of the system to be enhanced. A motion planning strategy is also developed to track the solar position and minimize the movements of two joints. Indoor experiments are conducted to test the accuracy of the state feedback and dynamic model. The performance of the uncertainty observer is also tested by experiments. At last, field experiments on the real water surface are implemented to verify the feasibility of the proposed system. The results show that the solar tracker is able to adjust the PV panels at a velocity of 8.89 deg/s under the effect of limited base motions with amplitude less than 4°. Note to Practitioners—Traditional solar trackers can be driven passively by chemical energy or actively using actuators. The former cannot function stably in the field environment, and the latter is complex in structure and energy-consuming. For the FPV system under the effect of waves, the solar tracker can utilize the motion of the base to align its PV panel to the solar position. Thus, we present a wave-driven solar tracker without using actuators, and brakes are applied to lock the position of joints. The proposed solar tracker is ener- y-efficient, has a simpler structure and hardware than the active one, and is more robust than the passive one. We model the system and propose a control scheme to drive the PV panel using inertia and gravity. We also observe the effect of winds to enhance the system robustness. The motion planning strategy is investigated to minimize the movements of the joints. The impact of base motion and control period on the energy-harvesting efficiency is analyzed by simulations. Both indoor and field experiments are implemented to verify the feasibility of the system. The experimental results show that the system performs well even when the base shacking is less than 4°. Note that the control algorithm is a model-based algorithm, which means the model parameters (inertia, gravity, etc.) need to be reidentified for different PV panels and system properties. That is a challenge for large-scale deployment with different configurations. Future research will address the system identification problem and enable the model parameters to be updated automatically.

Design, operation, and performance evaluation of a cable‐drawn dual‐axis solar tracker compared to a fixed‐tilted system

Design of compound solar tracking controller

An Analog Integrated MPPT Controller Designed for DMPPT Solar Array

High-Performance Global Maximum Power Point Tracking for Partial Shaded Photovoltaic Systems

Robust Design of Perturb & Observe Maximum Power Point Tracking for Photovoltaic Systems

A Maximum Power Point Tracking Control Scheme for PV System Based on Power Equilibrium and Its System Design

A new maximum photovoltaic power tracking control scheme based on power equilibrium at DC link

Design of Automatic Two-Axis Sun-Tracking System

Fabrication and Performance Analysis of a Higher Efficient Dual-Axis Automated Solar Tracker

Development of a Solar-Tracking System for Horizontal Single-Axis PV Arrays Using Spatial Projection Analysis

Performance Comparison of Solar Single-Axis Tracking Low-Concentrating Photovoltaic/Thermal System With Different Axes

Simulation and Optimization of a Dual-Axis Solar Tracking Mechanism

A Control Process for Active Solar-Tracking Systems for Photovoltaic Technology and the Circuit Layout Necessary for the Implementation of the Method

Performance Evaluation of a Second-Order Lever Single Axis Solar Tracking System

Development and evaluation of a microcontrolled solar tracker based on chronological positioning

Design and Implementation of Extremum-Seeking Control Based on MPPT for Dual-Axis Solar Tracker

Design and Control of a Wave-Driven Solar Tracker

Dynamic Monitoring and Analysis of Dual-Axis movement of SPV Power Plant Parameters under various Atmospheric Conditions

Evaluation of horizontal single‐axis solar tracker algorithms in terms of energy production and operational performance

Techno-economic performance modelling of bifacial and tracking PV systems worldwide