Controlling of ZnO nanostructures by solute concentration and its effect on growth, structural and optical properties

Yogendra Kumar,Amit Kumar Rana,Prateek Bhojane,Manojit Pusty,Vivas Bagwe,Somaditya Sen,Parasharam M Shirage
DOI: https://doi.org/10.1088/2053-1591/2/10/105017
IF: 2.025
2015-10-27
Materials Research Express
Abstract:ZnO nanostructured films were prepared by a chemical bath deposition method on glass substrates without any assistance of either microwave or high pressure autoclaves. The effect of solute concentration on the pure wurtzite ZnO nanostructure morphologies is studied. The control of the solute concentration helps to control the nanostructure to form nano-needles, and -rods. X-ray diffraction (XRD) studies revealed highly c-axis oriented thin films. Scanning electron microscopy (SEM) confirms the modification of the nanostructure dependent on the concentration. Transmission electron microscopy (TEM) results show the single crystalline electron diffraction pattern, indicating high quality nano-material. UV–vis results show the variation in the band gap from 3.20 eV to 3.14 eV with increasing concentration as the nanostructures change from needle- to rod-like. Photoluminescence (PL) data indicate the existence of defects in the nanomaterials emitting light in the yellow–green region, with broad UV and visible spectra. A sharp and strong peak is observed at ~438 cm−1 by Raman spectroscopy, assigned to the optical mode of ZnO, the characteristic peak for the highly-crystalline wurtzite hexagonal phase. The solute concentration significantly affects the formation of defect states in the nanostructured films, and as a result, it alters the structural and optical properties. Current–voltage characteristics alter with the measurement environment, indicating potential sensor applications.
materials science, multidisciplinary
What problem does this paper attempt to address?