Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Numerical Simulation of One-Sided Normal Zone Propagation in Large Helical Device Conductors

Numerical Analysis of Transient Transverse Hall Current in LHD Conductor

Overview of Hl-2a Experiment Results

Overview of Experimental Results on the HL-2A Tokamak

Direct numerical simulation of turbulent mixed convection in a vertical channel in a wall-normal magnetic field

Performance of the Helical Coils for the Large Helical Device in Six Years' Operation

Experimental Investigation on Liquid-Metal Flow Distribution in Insulating Manifold under Uniform Magnetic Field

Holistic numerical simulation of a quenching process on a real-size multifilamentary superconducting coil

Normal Zone Propagation Along Superconducting Wires In Superfluid Liquid-Helium

Numerical Study on Natural Convection of Liquid Nitrogen Used to Cool the High-Temperature Superconducting Cable in a New Combined Energy Transmission System

Isotope effects on transport characteristics of edge and core plasmas heated by neutral beam injection (NBI) in an inward shifted configuration at the Large Helical Device

Numerical Modeling of the Transition from Low to High Confinement in Magnetically Confined Plasma

Recent Advances in High-βN Experiments and Magnetohydrodynamic Instabilities with Hybrid Scenarios in the HL-2A Tokamak

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Observation of Inward Transport Flux Accompanied with the Long-Lived Mode During the L-H Transition in the HL-2A Tokamak

MHD Simulation on Magnetic Compression of Field Reversed Configurations with NIMROD

Optimization of the N || upshift in the DIII-D high field side lower hybrid current drive experiment

Experimental Observation of Zonal Flow and Its Scalings in Axisymmetric Magnetic Field

Analysis of normal zone propagation in pancake-shaped Nb/sub 3/Sn superconducting magnet

Simulations of the Effects of Pre-Seeded Magnetic Islands on the Generation of Runaway Current During Disruption on J-TEXT

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet