Abstract:The internal combustion engine will continue to be the primary source of power for transportation. Spark ignition (SI) engines are still widely used for mobility due to their wide range of operating conditions. The key operating variables of an engine are primarily controlled by an engine control unit that has been calibrated. However, a less accurate sensor can lead to large variations in engine performance and emissions. The purpose of this study was to investigate the importance of air-fuel ratio sensor precision during operation of various engines. In this study, a one-dimensional (1D) computational fluid dynamics (CFD) model was used to analyze the engine response due to the variation of the equivalence ratio sensor precision at different engine speeds and loads, to explore the main indicators influenced by the precision of equivalence ratio measurements, and to propose a discriminant criterion for evaluating the suitability of the proposed equivalence ratio precision in relation to the conversion rate of three-way catalyst and vehicle emissions. The results show that for engine performance, it varies slightly with small changes in the fuel-to-air ratio. At higher engine speeds, a slight change in the air-fuel ratio leads to a smaller change in emissions. At the same time, changes in fuel-to-air ratio have a significant effect on carbon monoxide (CO) and nitrogen oxides (NOx) emissions. Carbon monoxide is the most sensitive to the air-fuel ratio, followed by nitrogen oxides, while unburned hydrocarbons are not sensitive to it. And for the three measurement accuracies studied in this paper (0.5%, 1%, and 2%), the accuracies are acceptable, but combining the relative errors of the actual emissions of CO and in order to achieve accurate combustion control, it is recommended that the sensor accuracy should be at least higher than 1% for the port fuel injected engine investigated in this study.

A flywheel error compensation algorithm for engine misfire detection

An Accurate Discrete Current Controller for High-Speed PMSMs/Gs in Flywheel Applications

Misfire detection of an internal combustion engine based on vibration and acoustic analysis

Detection of Engine Misfire by Wavelet Analysis of Cylinder-Head Vibration Signals

A Sensor-Fault Tolerant Control Method of Active Magnetic Bearing in Flywheel Energy Storage System

Real-time misfire detection via sliding mode observer

Engine Misfire Detection Using Crankshaft Speed Multiple Filtering

Advanced gasoline engine misfire diagnostic method based on crankshaft speed multiple filtering

A Study on Misfire Detection for Electronically Controlled Gasoline Engine Based on Wavelet Transform Technique

The Engine Combustion Phasing Prediction Based on the Support Vector Regression Method

A Data-Driven Approach for Identification and Compensation of Wind Turbine Inherent Yaw Misalignment

Noise Analysis and Compensation of Momentary Crankshaft Speed of Automotive Engines

Intelligent Fault Diagnosis of Diesel Engines Via Extreme Gradient Boosting and High-Accuracy Time–Frequency Information of Vibration Signals

Vibration Control For Active Magnetic Bearing Rotor System Of High-Speed Flywheel Energy Storage System In A Wide Range Of Speed

Study of Engine Multi-Cylinder Random Misfire Detection

Engine Fault Detection Using Vibration Signal Reconstruction in the Crank-Angle Domain

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Adaptive Sliding Mode Observer for Updating Maps with an Application to Mass Air Flow Sensors in Diesel Engines

Real-Time Angular Velocity-Based Misfire Detection Using Artificial Neural Networks

A symbolic dynamic analysis of flywheel system for fault detection

The Investigation about a New Type of Misfire Detection Method in an Engine